太阳能发电峰会资料张祝林_安超Major_Test_Items_and_Requirements_in_UL1703_(2008.pptVIP

Major test items requirements in UL1703 UL1703主要测试项目及相关要求 General 概述 Types of Testing for PV module光伏组件的试验类型 Performance qualification testing 性能鉴定试验 minimum requirements for design qualification and type approval. 设计鉴定和产品定型认证试验的最低要求 Safety testing 安全性试验 minimum requirement for safety (module functionality is not required). 安全认证的最低要求(不特别强调产品性能) Reliability testing 耐久性试验 maximum durability (test until failure occurs). 产品性能的最大限度(试验到失效为止) Engineering evaluation testing 工程评估试验 evaluation and comparison of different designs and processing methods. 评估和比较不同的设计, 材料, 工艺等 Performance Standard vs. Safety Standard性能标准 vs. 安全标准 判断依据的差异 (after testing) The Standard - UL 1703 “Standard for Safety for Photovoltaic Modules and Panels” Evaluate electrical shock hazards 电击危害的审核 Product based 基于产品 Application based 基于应用 Evaluate fire resistance propagation hazards 火灾危害的审核 Product based 基于产品 Application based 基于应用 Verify evaluation through testing 通过测试审核产品 Provide descriptive information for subsequent “Follow-Up” inspection of manufacturing locations 为后续工厂审核提供依据 Test sequences and samples 测试序列和样品 Introduction for UL 1703 Testing 测试介绍 Temperature Test温度测试 Purpose 目的 To determine that module does not subject its surroundings to excessive temperatures (Ignite materials or components) 确定组件的零部件和材料不会由于过高的温度而起火 To determine the suitability of components and materials (Temperature Limits of components and materials) 确定组件的温度不会超过零部件和材料的温度限制 To determine there is no damage or deterioration 确定不会出现标准不允许的损坏和性能下降 Temperature Test温度测试 Test condition 测试条件 Ambient Temperature 40℃ 环境温度 Irradiance 1kW / m2, AM 1.5 辐照条件 Wind Speed, 1 m/s 风速 1) Open circuit conditions 开路条件下 2) Short circuit conditions 短路条件下 3) Short Circuit conditions with one-half shaded Cell 组件短路, 组件中一个电池片一半被覆盖. Temperature Test温度测试 What to measure? 测量哪些地方? Superstrate 盖板 Substrate 背板 J-Box 接线盒 Connector 连接器 Connecting Cable 连接线缆 Bypass Diode 旁路二极管 Temperature Test温度测试