Wincc在供热站恒压供水监控系统中的应用.doc

外文原文 Wincc in heating supply stapply stations Constant Pressure Monitoring System Application onstant voltage supply basic working principle System uses Automatic Frequency Control regulation or pump motor speed. Plus or minus pump.It is primarily by the Frequency Control System.PID regulator,pressure sensors,liquid level sensor power control circuits and other conponents.Host users control system or control board light over-the-counter transactions,buttons,switchto understand and control system operation,Based on the PID control mode,the operator interface settings in water pressure,PLC to pressure settings and measured values for the deviation PID operation and regulation of distribution through inverter pump speed,so that water pressure was maintained at the set value. System hanlware configuration The system uses Siemens S7-200 PLC and its configuration software constitute a constant WinCC V6.0 Water pressure control system,water pressure monitoring process.Industrial Etherical controller for PLC and the operator station computer communication between the Remote I/O network for the PLC and the operator station completer communication between the Remote I/O network for the PLC controller and inverter,the soft starter of communication between equipment.PLC controller mainly used to monitor and control water and electricity systems.For1#-4#pressurized pump converter using the ABB Acs510-01-031A4 inverter,HMI operationalism selection DELL computers,computer,Industrial Ethernet server card Siemens conmmunications company CP1612. Software design of System The control system software company Siemens PCS7V5.2 package,STEP7V5.2 PLC controller mainly used to monitor and control water and electricity systems.For 1#~4# pressurized pump converter using the ABB ACS510-031A4 inveter,HMI operatorstation selection DELL puter,Industrial Ethernet server card Siemens communications company Cp1612 Software design of System The control system software company Siemens PCS7V5.2 packag