Paper and Board Grades（下）.pdfVIP

Chapter 2 Paperboard grades made of bleached pulp, and its basis weight is the same as for white top linerboard. Board can be made of bleached pulp, and its basis weight is the same as for white top linerboard. Board can be coated either on machine or off machine. Typical coating is a single coating with a blade coater. coated either on machine or off machine. Typical coating is a single coating with a blade coater. Coated white top linerboard is used for demanding corrugated board applications, like for Coated white top linerboard is used for demanding corrugated board applications, like for containers that are used in a display in stores. containers that are used in a display in stores. Testliner is produced especially in Central Europe and in Asia. Various furnishes are used in Testliner is produced especially in Central Europe and in Asia. Various furnishes are used in testliner (Fig. 16). Because of the mixed waste used, a four-ply structure is often preferred for two testliner (Fig. 16). Because of the mixed waste used, a four-ply structure is often preferred for two reasons. First, by using four plies, the linerboard properties can be optimized better than with a reasons. First, by using four plies, the linerboard properties can be optimized better than with a two-ply structure. Second, since the drainage resistance of the mixed waste is very high, it would two-ply structure. Second, since the drainage resistance of the mixed waste is very high, it would be difficult to dewater one heavy base ply on the wire section. By splitting the base ply into 2−3 be difficult to dewater one heavy base ply on the wire section. By splitting the base ply into 2−3 plies, drainage on the forming section becomes a lot easier. plies, drainage on the forming section becomes a lot easier. Figure 16.Figure 16. Testliner.Testliner. Burst and cross machine directional compression strength are the most important strengthBurst and cross ma