预应力混凝土简支梁桥钻孔灌注桩锥形锚具AutoCAD.docVIP

预应力混凝土-简支梁桥-钻孔灌注桩-锥形锚具-AutoCAD-毕业论文 This is a partial struct design of a flyover crossing that is over the railway in GaokanShangguanbo according to designing assignment and the standard of road and bridge For the purpose of make the type of the bridge corresponding with the ambience and cost saving this paper provides two different types of bridge for selection the first one is pre-stressed concrete continuous bridge the second one is double cantilever half through no-thrust arch bridge After the comparisons of economy appearance characteristic under the strength and effect the first one is selected In this design The checking calculation of strength of main girder was preceded not only in prestressed statement but also in using statement deflectionprecamber and the assessment of reinforcing steel bar were checked too The pier of the bridge was basing on digging pile and adopted rubber pot bearing According to the characteristic of the overpass bridge and spot condition it adopted the method that the cantilever job placing combined with bracket job placing All of the design drawings were protracted by AutoCAD Except that the thesis called A note on dynamic fracture of the bridge bearing due to the great Hanshin–Awaji earthquake was translated into Chinese and made a report on Keywords prestressed concreteAutoCADsimple supported beam bridgecast-in-place pilecone anchorage device 目录 第一部分 桥梁设计 1 第一章 水文计算 1 11原始资料 1 12 水文计算 3 第二章 方案比选 6 21 方案一预应力钢筋混凝土简支梁锥型锚具 6 22方案二钢筋混凝土箱形拱桥 10 第三章 总体布置及主梁的设计 11 31设计资料及构造布置 11 32主梁内力计算 12 第四章 预应力钢束的估算及其布置 21 41跨中截面钢束的估算与确定 21 42钢束预应力损失计算 25 43截面强度验算 28 44预加内力计算 34 45主梁斜截面验算 35 46截面应力验算 41 47主梁端部的局部承压验算 46 第五章 下部结构的计算 51 51盖梁的计算 51 52桥墩墩柱计算 58 53钻孔灌注桩的设计计算 60 第二部分 英文翻译 63 Reliability analysis 63 可靠性分析 70 结束语 74 第一部分 桥梁设计 第一章 水文计算 11原始资料 111水文资料 浑河发源于辽宁省新宾县的滚马苓从东向西流过沈阳后折向西南至海城市三岔河与太子河相汇而后汇入辽河浑河干流长364公里流域面积11085平方公里本桥位上游45公里的大伙房水库于1958年建成该水库控制汇流面积5563平方公里对沈阳地区的浑河洪峰流量起到很大的削减作用