柔化银旋切参数对旋切单板质量的影响.PDFVIP

第 27 卷第 5 期 南京林业大 学学 报(自然科 学 版 Vol. 27 , No . 5 2003 年 9 月 Iournal of N aniing Forestrv Universitv{ N atural Sciences Edition) Sept., 2003 Effect of Veneer Peeling Parameters with an Incisor Bar on Veneer Quality 1 2 2 JIANG Shen-xue , DAI Chun-ping , WANG Jian-he (l. Nanjin g Forestry University , Nanjing 210037 , China; 2. Forintek Canada Corp. Vancouver , B. C. Canada) Abstract: An incisor bar and control system were installed on a min卜lathe to investigate the effects of incising veneer on veneer quality. Three controllable variables , i. e. knife pitch angle( PA) , verti- cal gap(VG) and horizontal gap(HG) with three level configurations were examined and com- pared. Each peeling setting of combination of three variables was repeated tw ice. Green and dry veneer thickness variation , green veneer CUI卡up， and dried veneer roughness were the veneer quali- ty indicators estimating whether a peeling setting was superior to another. The result showed that the best pitch angle should be 90. 50 , suitable vertical gap was 9. 84 mm , and the best horizontal gap was 2. 79 mm for the rotary peeling w ith an incisor bar used in this experiment. Key words: Incisor bar; Peeling par况neter settings; Veneer thickn臼s variation; Veneer currup; Veneer incising CLCnm般口TH132; TS653 Doctnnent Oxle:A Article ID: 1000- 2006( 2003) 05- 0001- 05 柔化银旋切参数对旋切单板质量的影响 蒋身学戴春平2 王建和2 ( l.南京林业大学，江苏 南京 210037; 2. 加拿大 Forintek 研究所，加拿大温哥华) 摘要:在胶合板生产中， 用柔化辑取代固定压尺可释放单板内应力、降低单板厚度偏差和卷曲变形。为