Part 7 - Spectral Earthquake SACST 培训教材.pdf

Part 7 - Spectral Earthquake Preparation 1) Under “Training Project”, create “Spectral Earthquake” subdirectory 2) Under “Spectral Earthquake”, Create “Static SE”, “Modes” and “Spectral Seismic” subdirectories. 3) Copy SACINP.DAT model file, SEAINP.DAT Seastate file and PSIINP.DAT soil data from “Static PSI” directory to “Static SE” directory. Rename the model file to SACINP.STA and Seastate file SEAINP.STA. Creating foundation superelement under “Static SE” directory, 1) Modifying model SACINP.STA Add a weight combination line to combine deck weight groups for dynamic analysis. Using Data generator to add a WTCMB line to combine AREA, EQPT, LIVE and MISC to MASS, 0.75 factor will be used for LIVE weight. Add a DYNMAS line to pass combined deck weight group MASS and jacket weight groups ANOD and WKWY for Dynpac weight. Using Precede define retained degree of freedom for Dynpac analysis. 2) Modifying model SEAINP.STA Delete all load cases and load combinations. Delete load case selection line and allowable stress modifier lines. Add a DEAD load case along with selected weight groups ANOD and WKWY. Add a load case MASS, using weight group MASS, add 1.0 G z direction acceleration and excluding structural self weight to account for additional deck loads. Add two additional load cases GRVX and GRVY, add 0.08 G x and y accelerations for weight group MASS, ANOD and WKWY with structural weight included respectively. Three load combinations will be added, load combination EQKS will be used for combining static load with dynamic earthquake loads. Load combination SUPX and SUPY will be used for foundation superelement creation for Dynpac analysis. EQKS = DEAD + MASS SUPX = DEAD + MASS + GRVX SUPY = DEAD + MASS +