Indirect Sliding Mode Control of Power Converters Via Double Integral Sliding Surface.pdf英文资料.pdfVIP

600 IEEE TRANSACTIONS ON POWER ELECTRONICS, VOL. 23, NO. 2, MARCH 2008 Indirect Sliding Mode Control of Power Converters Via Double Integral Sliding Surface Siew-Chong Tan, Member, IEEE, Y. M. Lai, Member, IEEE, and Chi K. Tse, Fellow, IEEE Abstract— The steady-state regulation error in power converters steady-state errors of SM controlled systems can be effectively that use the conventional hysteresis-modulation-based sliding suppressed through the use of an additional integral term of the mode controller can be suppressed through the incorporation state variables in the SM controller [9], [14], [19], [21], [23], of an additional integral term of the state variables into the controller. However, it is found that with the indirect type of [25]. This method is known as integral SM control. When in- sliding mode controller (derived based on the equivalent control corporated, the consequence is an SM controlled system 1) with approach), the same approach of integral sliding mode control motion equation of the same order as the original system; and is ineffective in alleviating the converter’s steady-state error. 2) with better robustness and regulation property than the tradi- Moreover, the error increases as the converter’s switching fre- tional SM controlled system [1]. quency decreases. This paper presents an in-depth study of the phenomenon and offers a solution to the problem. Specifically, it is Interestingly, in a recent attempt to implement a type of proposed that an additional double-integral term of the controlled fixed-frequency indirect SM controllers, which is based on variables to be adopted for constructing the sliding surface of pulsew