机械镀锌中超声功率对镀层耐腐蚀性能的影响-表面技术.PDFVIP

摇 摇 摇 表面技术 第44卷摇 第1期 ·64 · SURFACE TECHNOLOGY 摇 2015年01月 試試試試試試試試試試試試試試試試試試試試試試試試試試試試試試試試試試試試試試試試試試試試試試試試試 膜层技术 机械镀锌中超声功率对镀层耐腐蚀性能的影响 牛宗伟,徐明玉,李明哲 (山东理工大学 机械工程学院,山东 淄博255049) 摘摇 要: 目的摇 探究超声波功率对镀层耐腐蚀性的影响规律。 方法摇 将超声波功率分为50,70,90,110 W4 个等级,利用湿法超声机械镀锌设备制备4种镀层。 用多功能扫描电子显微镜观察镀锌层的微观表 面形貌,并分析镀锌层厚度,测试镀锌层的耐腐蚀性能以及镀层与基体的附着强度。 结果摇 功率为50 W 时获得的镀层厚度最大,表面质量、耐腐蚀性能最差;功率为110 W 时获得镀层表面质量、耐腐蚀性能最 好。 结论摇 随功率的增大,镀层表面质量明显提高,镀层耐腐蚀性有逐渐增加的趋势。 关键词:超声波功率;机械镀锌;表面形貌;耐腐蚀性 中图分类号:TQ153.1摇 摇 摇 文献标识码:A摇 摇 摇 文章编号:1001鄄3660(2015)01鄄0064鄄04 Effect of Ultrasonic Power in Mechanical Galvanizing on the Corrosion Resistance of the Coating NIUZong鄄wei,XUMing鄄yu,LI Ming鄄zhe (School of Mechanical Engineering,Shandong University of Technology,Zibo255049,China) ABSTRACT:ObjectiveToexploretheinfluencinglawoftheultrasonicpoweronthecorrosionresistanceofthecoating. Methods Under thefourlevelsofultrasonicpower(50,70,90,110 W),fourkindsof mechanicalzinc鄄coatingswerepreparedbyWetultra鄄 sound mechanical galvanizing equipment. The surface topography of the coatingswas observed and studied by SEM. The coatings thicknesswas measured,the corrosion resistance was determined and the bonding strength between the coating and the substrate was studied.Results When the ultrasonic power was 50 W,the corrosion resistance and surface quality of the zinc鄄coating were worse than those of others. Whilethe corrosion resistance and surface quality of the zinc鄄coatingwerethe best when the ultrasonic power was 110 W. Conclusion The surface quality of the coating was significantly improved and the corrosion resistance of the coating showed an increasing tre