2009丰田普锐斯(PRIUS)底盘培训课件.ppt

* * The structure is same as COROLLA/AURIS * [Parking brake lever travel adjustment]驻车制动杆行程调整 Release the parking brake lever. 　放松驻车制动杆 2. Loosen the lock nut and adjusting nut, and fully loosen the parking brake cable (the operation lever touches the stopper). 　松锁螺母和调整螺母，并完全放松驻车制动拉索（操作杆接触限位） 3. Strongly depress the brake pedal a few times (engine OFF). 　用力踩制动踏板几次（发动机停止） 4. Tighten the adjusting nut and apply the parking brake to remove cable looseness. 　上紧调整螺母来施加驻车制动来消除拉索的松驰。 5. Turn the adjusting nut until the lever travel is correct. 　上紧调整螺母直到杆行程正确。 6. Tighten the lock nut. 　上紧锁螺母。 7. Apply the parking brake a few times then check the parking brake lever travel. 　施加驻车制动几次再检查驻车制动杆行程。 8. Release the parking brake lever and check the brake drag of the rear brake by the rear wheel. 　放松驻车制动杆，检查后轮制动拖滞。 9. Confirm the clearance between the operation lever and stopper at the parking brake released. Standard: 0 – 0.5 mm (0 – 0.02 in.) 　在放松驻车制动时确认操作杆和限位的间隙 　　标准： 0 – 0.5 mm (0 – 0.02 in.) * This function blinks the stop light at sudden braking to reduce the risk of rear-end collision This function is used only for the European and Australia models * During operation, stop light blinks at approx. 4 Hz [Operation Start Conditions (AND)] - SPD is more than 55 km/h (34 mph) - Driver depresses the 制动 pedal - Vehicle deceleration exceeded specified value [Operation Cancel Conditions (OR)] - Driver releases the 制动 pedal - Vehicle deceleration became less than specified value - Driver pushes the hazard warning light switch * Capacitor is discontinued * lj * lj * lj * When the 制动 system is failure, the switching solenoid valve (SSC) is closed and the fluid flow is shut off from the 主缸. lj * lj * Absolute angle type 转向 angle sensor is the same as AVENSIS and VERSO. Specified Value: 7.7 degrees * [Vehicle Condition] Shift lever is in P Parking 制动 is applied * Select ECB (Electronically Controlled 制动 system) Invalid Mode Perform the procedure listed below in 1 minute Turn the power