探月返回器伞舱盖拉伞包动力学模型 Dynamic Model of Parachute Pack Pulling Process by Parachute Container Cover.pdfVIP

第34 卷 第4 期 航天返回与遥感 2013 年8 月 SPACECRAFT RECOVERY REMOTE SENSING 25 探月返回器伞舱盖拉伞包动力学模型 夏刚 1 郭鹏 2 秦子增 1 (1 国防科学技术大学航天科学与工程学院，长沙 410073) （2 中国空气动力研究与发展中心，绵阳 621000 ） 摘 要 文章针对探月返回器伞舱盖弹射分离后出现的物理现象，建立了伞舱盖弹射分离拉伞包过 程动力学模型，复现了伞舱盖弹射分离试验中观察到的伞包追赶伞舱盖现象，比较了地面静止弹盖条件 及飞行条件下拉伞包过程的异同，分析了主要设计参数对拉伞包过程的影响。研究表明，对于现有弹盖 系统，伞包拉出后均存在追赶伞舱盖的现象，并且这一现象无法通过调整弹射分离速度、伞舱盖质量及 连接点位置得以避免。 关键词 伞舱盖 伞包 动力学模型 追赶现象 航天返回 中图分类号: V476.2 文献标志码: A 文章编号: 1009-8518(2013)04-0025-09 DOI: 10.3969/j.issn.1009-8518.2013.04.004 Dynamic Model of Parachute Pack Pulling Process by Parachute Container Cover 1 2 1 XIA Gang GUO Peng QIN Zizeng (1 College of Aerospace Science and Engineering, NUDT, Changsha 410073, China) (2 China Aerodynamics Research and Development Center, Mianyang 621000, China) Abstract Based on the overtaking phenomenon during the lunar capsule’s parachute container cover separating from the cabin, a dynamic model was established to analyze the parachute pack pulling procedure. The simulation results could reproduce the chasing phenomenon observed during the tests, the similarities and differences of the results of different conditions are compared, and then the influences of the major design pa- rameters are discussed. The study shows that the overtaking phenomenon, which would be inevitable if the cover separation unit uses an elastic belt to connect the cover and the pack, and could not be avoided by only adjusting the main parameters such as the separation velocity, the mass of the cover or the position of the joint. Key words