消音器上面第二节吊装方案.docVIP

LIFTING DIRECTION OF LINE1 DUCT OF CE1CB05 1号线 Project No. : CM8896 Project Name: KONIAMBO NICKEL PROJECT Customer : EQUIP KONIAMBO Site : NEW CALEDONIA 00 16.JAN.2012 For Approval SHAOYT REV. DATE DESCRIPTION PREP’D CHK’D APP’D APP’D DATE CLIENT  概述General This article offers guideline for the of LINE 1 DUCT CE1CB05. 此方案描述了1号线 2、参考文件REFERENCE DOCUMENTS EK公司给的图纸Drawings by EK。319000-00300-A2001-4100-0007-5026 3、施工内容 Items to be installed L 把风管吊装到安装高度（标高64米）。 4、吊装注意事项LIFTING PRECAUTIONS 4.1 All the heavy lifting equipment, slings and pulleys must be subject to careful calculation and inspection prior to use. 施工前，所有起重搬运机具、钢丝绳和滑轮等，必须经过检验和验算，证明确实可靠后方可使用。 4.2 Operation for the heavy equipment must strictly follow the safety rules relevant to operation and construction. 操作起重机械，必须严格遵守安全操作规程及有关施工安全规定。 4. The equipment shall be lifted according to the sling point specified by the anufacturer. If such hoisting position is not clearly stated, center of gravity shall be determined. 起吊设备时，必须按设备出厂标志的吊装位置起吊，无明显标志时，应事先找好重心，确定受力部位 4.4 When 2 or more slings are used for lifting, each sling shall take equal stress; the angle between perpendicular and stress direction shall be no bigger than 300 用两根以上的钢丝绳起重时，每根钢丝绳受力应均匀，并与垂线所成的夹角不得大于300 4.5Slings for equipment lifting shall not contact directly with the corners and finish surface of the equipment. Pads shall be applied on these points, in order to prevent damage to the finish surface and wire. 吊装绳索不能与设备的加工面或棱角处直接接触，必须垫以木板、胶皮等物，以防损坏加工面和切断吊装绳索。 5、安装前准备PREPARE FRONT OF INSTALL 5.1Review the drawings； 图纸是否已经熟悉 5.2Temporary placement identification of the members； 设备构件的临时摆放位置，找到构件 5.3Check for the quantity, size direction of the members； 核对构件的数量、尺寸、方向 6、装步骤 STEPS 6.1Firstly, we should conform the quality of the welding lug again. 首先，我们应该再次确认焊接吊耳质量合格； 6.2Prepare method statement as per drawing and get approved by signature from relevant dep. 根据图纸信息制定施工指导书，并得到相关部门的签字确认；