1602电子密码锁c程序.doc

#includereg52.h #define uchar unsigned char #define uint unsigned int sbit lcdrs=P2^4; //液晶数据、指令端 sbit wr=P2^5; //读、写端 sbit lcden=P2^6; //液晶使能端 sbit speaker=P2^3; //扬声器 uchar code table[]={enter password:}; uchar code table1[]={error!try again:}; uchar code table2[]={ welcome!!!}; uchar code table4[]={set password:}; uchar code table5[]={input again:}; uchar code table6[]={ fuck you!}; uchar code table7[]={ get out!!}; uchar code table8[]={ set succeed}; bit flag,flag1,flag2,flag3,flag4,flag5,rst; uchar key,count; void delayms(uint x) { uint i,j; for(i=x;i0;i--) //延时函数 for(j=110;j0;j--); } void write_com(uchar com) //液晶写指令函数 { wr=0; lcdrs=0; P0=com; delayms(5); lcden=1; delayms(5); lcden=0; } void write_data(uchar date) //液晶写数据函数 { wr=0; lcdrs=1; P0=date; delayms(5); lcden=1; delayms(5); lcden=0; } //液晶初始化函数 void lcdinit () { lcden=0; write_com(0x38); write_com(0x06); write_com(0x0f); write_com(0x01); } void keyscan() //键盘扫描函数 { uchar temp; P1=0xfe; if(P1!=0xfe) { delayms(8); if(P1!=0xfe) { temp=0xf0P1; switch(temp) { case 0xe0: key=0;flag5=1;break; //数字键盘按下时显示‘*‘字符，把对应的数字放入数组中 case 0xd0: key=1;flag5=1;break; //flag5为1时才能把数据放进数组，只是为了防止删减密码 case 0xb0: key=2;flag5=1;break; //时把key的值装进已输入正确的密码中 case 0x70: key=3;flag5=1;break; } while(P1!=0xfe); write_data(*); count++; } } P1=0xfd; if(P1!=0xfd) { delayms(8); if(P1!=0xfd) { temp=0xf0P1; switch(temp) { case 0xe0: key=4;flag5=1;break; case 0xd0: key=5;flag5=1;break; case 0xb0: key=6;flag5=1;break; case 0x70: key=7;flag5=1;break; } while(P1!=0xfd); write_data(*); count++; } } P1=0xfb; if(P1!=0xfb) { delayms(8); if(P1!=0xfb) { temp=0xf0P1; switch(temp) { case 0xe0: key=8;write_data(*);flag5=1;count++;break; case 0xd0: key=9;write_data(*);flag5=