拉法基水泥集团--设备调试说明23.docVIP

Test Commissioning No Load Test: Individual Equipment Fan (Power 45KW) No of pages / Equipment Item: Issue Date:10th Oct., 2008 Rev: R01 Item N° Sheet No. MPT - Single Machine Electrical Protection Interlock Test; MPT - 单机设备保护联锁测试 Lubrication And checking before starting 润滑和启动前检查 Lubrication 润滑 All elements or components are added right lubrication oil before starting. And the right label should be near the lubrication point. 在启动前，所有的部件已经正确添加了润滑油。并且已润滑标签应当贴在润滑点附近。 Grease 油脂 Motor bearings drive and non drive 电机驱动端及非驱动端轴承 Fan bearings drive and non drive (if have) 风机驱动端及非驱动端轴承 Oil 润滑油 Variable speed coupling, Fan bearings drive and non drive (if have) 液力隅合器，风机驱动端及非驱动端 Fan bearings drive and non drive (if have) 风机驱动端及非驱动端轴承 □ □ □ □ □ Security Check 安全检查 No sundries inside the fan casing and duct. 检查风机、风管内部无杂物。 All safety device installed; 所有安全防护装置安装到位; Safety warning string and warning plate. 悬挂安全标识牌和警戒线。 □ □ □ Mechanical check and adjustment 机械检查和冷却水 Check the anchor bolts of fan bearing and motor, variable coupling, vibration pads 检查风机及电机地脚螺栓是否紧固，联轴器已连接好 Close all man-holes, 关闭所有的检查孔门。 Cooling water run smoothly and no leakage, Pressure test without leakage 冷却水畅通，无漏水 The lubrication staion part runs well. 润滑油站工作正常 Manually run the fan rotor 3 to 5 circles to make sure no abnormal noise. 人工盘动风机转子3~5圈，无异常声音 Check clearance between the impeller disk and fix part (no friction and no too much clearance). 检查叶片内无异物，无摩擦 Inspect the shaft seal clearance 检查风机轴密封 Check the fan connection with the duct (seal or expansion seal). 检查风机连接网管（密封及膨胀节处密封） Check the duct inlet and outlet: not supported by the fan or the fan seal. 检查风管进出口：风机无外受力 □ □ □ □ □ □ □ □ □□ Key Point for Individual Test 单机试车期间检查内容 Motor direction test must be completed 电机方向测试必须进行 The duration of individual test should be 单机试车运转时间为： 8hours 8小时 Following items should be checked during the individual test: 单机试车期间，下列项目应当检查： Test the process fan in different condition (damper adju