RMAN与带库.doc

Skip Headers Oracle9i Recovery Manager Users GuideRelease 2 (9.2)Part Number A96566-01 Home Book List Contents Index Master Index Feedback 8Configuring the Recovery Manager Environment This chapter describes how to perform setup and configuration tasks. This chapter contains these topics: Configuring RMAN to Make Backups to a Media Manager Configuring Automatic Channels Configuring the Control File and Server Parameter File Autobackup Configuring the Backup Retention Policy Configuring the Maximum Size of Backup Sets Configuring Backup Optimization Configuring the Number of Backup Copies Configuring Tablespaces for Exclusion from Whole Database Backups Setting Globalization Support Environment Variables for RMAN Configuring the Snapshot Control File Location Setting Up RMAN for Use with a Shared Server Setting Up a Recovery Catalog Configuring RMAN to Make Backups to a Media Manager On most platforms, to back up to and restore from sequential media such as tape, you must integrate a media manager with Oracle. A media manager is not an Oracle product and must be obtained from a third-party vendor. If you choose to use RMAN with a media manager, then you must obtain all product-specific information from the vendor. This section describes the generic steps for configuring RMAN for use with a media manager. The actual steps depend on the media management product that you install and the platform on which you are running Oracle. Read the following sections in order when configuring the media manager: Prerequisites for Using a Media Manager with RMAN How Oracle Interacts with the Media Manager Integrating RMAN with the Media Manager: Basic Steps Testing Whether the Media Manager Library Is Integrated Correctly Configuring Automatic Channels for Use with a Media Manager See Also: Media Management for an overview of media management software and its implications for RMAN Prerequisites for Using a Media Manager with RMAN Before you can begin us