[工程科技]进口风机知识.ppt

* * * * The fan laws can now be used to determine additional fan performance at varying at varying fan speeds (RPMS). * The operating point can be changed in two ways: The first is: If the system stays the same and the fan rpm changes, then the new point will move up or down the system resistance curve. (For example, if the fan rpm is cut in half, the new operating point will be at the intersection of the blue line and red line) * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * This is very important, since all fan curves follow these laws: As rpm increases, cfm increases at the same ratio. As rpm increases, static pressure increases as the square (higher ratio). As rpm increases, brake horsepower increases as the cube (much higher ratio). So, if rpm is increased 1/3, the horsepower is 2.4 times higher. * This is very important, since all fan curves follow these laws: As rpm increases, cfm increases at the same ratio. As rpm increases, static pressure increases as the square (higher ratio). As rpm increases, brake horsepower increases as the cube (much higher ratio). So, if rpm is increased 1/3, the horsepower is 2.4 times higher. * This is very important, since all fan curves follow these laws: As rpm increases, cfm increases at the same ratio. As rpm increases, static pressure increases as the square (higher ratio). As rpm increases, brake horsepower increases as the cube (much higher ratio). So, if rpm is increased 1/3, the horsepower is 2.4 times higher. * * AMCA International stands for the Air Movement and Control Association International. * * * * * * * AMCA International certifies that the fans will perform to what is shown in the catalog, if it is installed the way it was tested. The fan manufacturer normally test their fans in the way they will most commonly be used. The applicable statements for the certified product is shown under the certified data in the manufacturer’s catalog. If the fans are not installed the way the were tested, then