沃尔夫CCIE实验室CCIE LAB课件12.ppt

沃尔夫CCIE实验室 CCIE LAB V31 Section4: ISDN Section5: Feature Section 3: ISDN ISDN交换类型、SPID和电话号码可以从设备架上获得 使用PPP封装，CHAP验证 R5 R3双向PING通 R5能在流量负载超过50％的时候启用第二B信道 Section 3: ISDN(续1) 将ISDN链路放进OSPF area 33 当r5连接VLANB的接口down掉的时候，r5能通过备份链路学到路由,不能用backup interface 以下条件不能导致ISDN flap a.当R3能通过Sw1到达R5时 b.除非拓扑发生变化 c.当完成BGP的配置以后 Basic配置部分: R3: isdn switch-type basic-ni username Rack01R5 password cisco ！ interface bri0 ip address isdn spid1 [本端SPID] encapsulation ppp ppp authentication chap ppp multilink no peer neighbor-route Section 4: Features 1. Span There is a network analyzer attached ports 0/20 at SW1. Configure SW1 so the network analyzer can receive the messages input and output of the port 0/19. monitor session 1 source interface fa0/8 both (在show run 的时候不显示both) monitor session 1 destination interface fa0/9 (接分析仪） About SPAN You can analyze network traffic passing through ports or VLANs by using SPAN to send a copy of the traffic to another port on the switch that has been connected to a SwitchProbe device or other Remote Monitoring (RMON) probe or security device. SPAN mirrors received or sent (or both) traffic on a source port and received traffic on one or more source ports or source VLANs, to a destination port for analysis About SPAN Destination Port When it is a destination port, it does not participate in any of the Layer 2 protocols— Cisco Discovery Protocol (CDP), VLAN Trunk Protocol (VTP), Dynamic Trunking Protocol (DTP), Spanning Tree Protocol (STP), Port Aggregation Protocol (PagP), and Link Aggregation Control Protocol (LACP). Section 4: Features 2. ATM Config ATM connection on R6 ATM3/0, use PPP0A and PVC 400+YY and IP address 192.3.Y.1/24. You must map statically and can’t use inverse ARP. After finish config, you should be able to ping ATM backbone use IP address 192.3.YY.254. ATM interface atm 3/0 pvc 0/400+YY encap aal5ciscoppp virtual-template1 protocol ip 192.3.Y.254 bro int virtual-template 1 ip ad