单片机发发光器设计中英文对照.docVIP

Microcontroller-Based Optical Transceiver Design 1 Introduction Under the impetus of the “Three Net Combined”, Fiber access programme such as FTTH (fiber to the home) is widely used. Under the voice of the light for copper, the optical network is developing rapidly. Optical transceiver plays a role of electro - optical, electro - optical conversion in optical communications, and is an essential device for optical communication. As it relates to high-speed circuit design, precision machining and optical design, the cost of optical transceivers occupies an important part in fiber optical communication systems and while the high prices of optical transceivers become the bottleneck of restricting fiber access promotion. Further reduce the cost of optical transceivers will benefit to promote the application of optical access and speed up the pace of light for copper. Optical transceiver mainly consists of circuits, optical transmitter components and optical receiver components. And the Part of the circuit which also includes laser driver, optical receiver signal amplifier and control section. In current ,The circuit part of optical transceivers on the market is using three specific chip. The company has always been in the study of laser driver and receiving signal amplifier circuit integration in a device, with the controller using the common embedded processor solutions. Due to only use a specific chip and a common chip, we can significantly low the cost of the circuit part. The PHY1076 chip developed by PHYWORKS company is such a chip. It is intended mainly for 1.25Gbps to 2.5Gbps optical transceiver with a simple external circuit, and it requires only an ordinary 8-bit microcontroller to realize the control circuit. This paper studies the performance of the PHY1076 which controled by the selected ATMEL companys ATMEGA88 microcontroller, designed the optical transceiver samples, and conducted the performance test, with the ultimate success of the design of the 1.2