热烈法玻璃激光切割技术综述.ppt

少见原因引起的颅内静脉窦血栓形成课件突发心跳呼吸骤停抢救应急演练课件小学英语教学法英语教学原则阻滞剂在减低非心脏手术 Review：The Influence Of Laser ScribingCutting Conditions In Glass Cutting LeeHang Class：134 No:2111302042 Instructor:Baoym Contents 1 2 3 4 Introduction Typical Experiments Results Comparison Prospect References Introduction The traditional methods of glass cutting are based on scoring and snapping in which a diamond blade tool is used for scribing,which weakens the glass surface and then breaking is done by applying the mechanical force. Although the method is relatively simple, it results in the weakening of glass edges by up to 60% due to the formation of microcracks and generation of residual stresses. To reduce these defects, glass can be grounded, polished, and heat treated but these techniques can only recover only up to 30% of the glass strength. Introduction Different techniques of cutting glass using laser exists such as laser scribe and break, laser melting and evaporation, and the controlled fracture technique from which some are being used in industries and some are still in their developmental stages. Laser scribe and break is a two stage process and is quite similar to traditional mechanical scribe and break method. In the first stage, partially penetrating holes or deep vents at depths of onethird to one-half of the material thickness are produced using a laser. In the second stage, breaking by applying a mechanical force takes place normally with the help of vacuum chucks or by crack rollers. Several studies have been done to improve this method and the cutting quality. However, the scribing and breaking process incurs damage to the cut edge and causes damage to the glass surface. Therefore, finishing processes are required, which add extra cost to the manufacturer. Introduction In laser melting and evaporation method, cutting is done above glass transition temperatureTg, which results in poor surface finish and heat affected zones. Due to melting and vaporization of the gl