2×135MW热电厂电气一次部分设计.docVIP

毕业设计 题 目： 院 系： 专 业： 班级学号： 学生姓名： 指导教师： 成 绩： 2016年 月 25日 目 录 摘要 电力系统是以发电、变电、输电和用电环节组成的电能生产与消费的一个完整的系统。电气主接线也称为电气主系统一次接线，它是发电厂、变电所电气设计的主体，也是电力系统网络的重要组成部分。电气主接线反映了发电机、变压器、线路、断路器和隔离开关等有关电气设备的数量、各回路中电气设备的连接关系及发电机、变压器与输电线路、负荷间的连接方式，直接关系到电力系统的可靠性、灵活性和安全性。 本次设计一个装机容量为2×135MW的热电厂，考虑分期实施，2台100MW发电机变压器组，1台50MW发电机变压器组。热电厂有220kV和35kV两个升高压等级，最大输送功率300MW。通过2回220kV和1回35kV联络线与邻近的一个220kV和一个35kV的变电站并网；220kV母线采用双母线接线方式、35kV母线采用单母线接法方式。本设计满足可靠性和灵活性，并且考虑运行的经济性。 关键词：发电厂、电力系统、短路电流、配电装置、同期。 abstract Electric power system is a complete system of production and consumption of electricity, which is composed of power generation, power generation, electricity transmission and electricity consumption. Electrical main wiring is also known as the main electrical wiring, which is the main power plant, substation electrical design, but also an important part of the power system network. The main electrical wiring reflects the generator transformer circuit breaker and isolating switch on the number of electrical equipment, electrical equipment in each loop connection and generator transformer and transmission line load and the connection between is directly related to the power system reliability, flexibility and security. The design of an installed capacity of 135MW thermal power plant, considering the phased implementation, 2 sets of 200MW generator transformer unit, 1 sets of 300MW generator transformer. Thermal power plant has 220kV and 35kV two liters of high voltage levels, the maximum transmission power of 700MW. Through 2 times of 220kV and 1 back 35kV tie line and adjacent to a 220kV and a 35kV transformer substation; 220kV bus using double bus connection mode, 35kV bus using single bus connection method. This design meets the reliability and flexibility, and considers the economic performance of the operation. Key words: power plant,