斗轮堆取料机使用维护说明书.doc

斗轮堆取料机使用维护说明书 二零一八年四月 目 录 Contents 设备环境及性能 Environment and functions of equipment 主要结构和技术参数 Main structure and technical data 工作原理与机构概述 Working principle and constitution 斗轮机使用说明Operation instruction about the bucket wheel stacker and reclaimer 操作及维护说明operation and maintenance specification 易损件明细表： List of wearable parts:The instruction only describes the safety operation, inspection and maintenance of the mechanical part.(instruction of electrical control system is in the electrical instruction) 设备环境及性能Equipment environment and functions .1环境climatic condition 周围气温ambient temperature：max 4C 相对湿度relative humidity：%  工作环境：极端积满灰尘和腐蚀性 Working condition: extremely dirty and causticity 工作风速working wind speed： 70Km/h non-working wind speed：10Km/h1.2 设备性能 Equipment functions 堆料能力stacking capacity：1200 t/h reclaiming capacity： 300t/h 回转半径slewing radium： 3 m 回转角度slewing angle： ±110°物料： 煤 material: coal 粒 度granularity： 00mm密 度density： 0.65~0.78t/m3 堆 积 角repose angle：含水率humidity：m轨下：1.5mheight of pile: up rail 12m down rail 1.5m 轨距rail distance： 7 m 轨道型号rail type：50kg/m 走行距离：约146 m travel distance: appr. 146m 尾车型式：半趴式单尾车，折返取料  type of tripper: fix type 供电方式：电缆卷筒 power supply: cable drum 供电电压supply voltage： 6000v 50Hz 供电位置： 料场中部 power supply position: center of material yard 地面带式输送机：（理论带面距轨顶）：1000mm ground belt conveyor: (from top plane of horizontal idlers of upper idlers to top of the rail) 带宽width：1400 mm 带速 speed：2.5 m/s 主要结构和技术参数main structure and technical data main structure 臂式斗轮堆取料机主要由斗轮机构、上部金属结构、悬臂带式输送机、俯仰机构、 转台、回转机构、门座、行走机构、中心落料斗系统、半趴式折返尾车、放缆系统、 电气室、司机室、润滑系统、洒水系统、检测系统、配重、电控系统、电缆卷筒等 部分组成。（见图d696p）cantilever bucket wheel stacker and reclaimers are composed of bucket wheel unit, boom, cantilever belt conveyor, hydraulic luffing unit, slewing driving unit, gate seat frame, traveling mechanism, middle material feeding tripper, semi-grovel back-folding tail car, cable system, electronic room, operating