Chapter11 Worm Gears 机械零件设计英文PPT全套教案幻灯片课件.pptVIP

Chapter 11 Worm Gears ; 11.1 Worm Gears and Worms; Nomenclature,  Materials;Sketch of worm gear arrangement for cylindrical (single-enveloping) worm, giving standard nomenclature. ;Worm shaft support bearings are typically subjected to radial loads and high thrust loads, and so with worm wheel bearings. If a rotating worm is constrained axially by thrust bearings, the worm gear is caused to rotate about its own axis, as the worm threads slide sidewise against the gear teeth. This simulates the kinematic behavior of a linearly advancing rack engaged with a conjugate spur or helical gear. ;In the wormset, a bronze gear is usually paired with a hardened steel worm. High-tin bronze ZQSn10-1 and ZQSn5-5-5 Tin-free bronze ZQAl9-4 and 10-4-4 gray cast iron HT150. Worms are ordinarily made from carbon or alloy steel . Worms of steel 15Cr, 15CrA, 10Cr, 20CrV are casehardened to surface hardness of . Worms of steel 40, 45, 40Cr and 40CrNi are hardened to . ;To insure proper contact between the worm and the gear teeth, the gear hob typically has the same basic cutter shape used for the worm. Worms may be manufactured with a single thread or with multiple threads. The number of threads on the worm is often referred to as the number of starts. The pitch diameter of a worm is not a function of its number of threads. The reduction ratio of a worm gear-set is not equal to the ratio of gear and worm pitch diameters, but equal to the ratio of the number of stars on the worm and teeth number on the gear.; The lead, the axial advance of any point on the worm thread for one revolution of the worm, is ; Correction of the worm gear;Sliding velocity vs at pitch point C, is;11.3 Force Analysis;11.4 Stress Analysis and Design; Stress analysis;Allowable surface stresses are assigned for the material of the wheel rim depending on the material of the worm running with it. When the wheels are made from cast iron