金属磁记忆检测仪器的研制与试验分析-development and experimental analysis of metal magnetic memory detection instrument.docxVIP

AbstractMetal magnetic memory technology is a kind of non-destructive testing technology which rising in recent years. Compared with other conventional electromagnetic non-destructive testing techniques, it does not require an excitation source, coupling agents, and it does not need to perform any of the workpiece surface inspection process. It is a kind of safety and environmental protection detection technology. Since its birth, it has drawn attention of numerous researchers, engineers and technicians by its advantage of early-stage pre-diagnosis of the ferromagnetic component and is widely used in the actual testing equipment of ferromagnetism. But as a young non-destructive testing technology, researchers cannot ignore its immaturity. So in practice detection process of magnetic memory testing missing and false detection often occur. The fundamental reason is that current research on NDT techniques in information extraction level magnetic flux leakage signal is not perfect, which can not make full use of the information of collected signals to improve the reliability and credibility of the testing results. This article is a breakthrough in signal analysis, searching for information about the magnetic flux leakage signal that may be more practical to detect magnetic memory, in order to provide technical support to further improvement of the metal magnetic memory technology.This article firstly analyzes the shortcomings of the current development of magnetic memory testing method and magnetic memory testing technique, with two-dimensional magnetic memory technology as the basis of the research projects, while extracting the surface magnetic flux leakage signal component tangential component of H(x) and normal component of H(y) as an indicator of the two signals together to achieve the dual criterion, accurately determining the stress concentration sites. And then it analyzes and evaluates the force to achieve good calculation of component phase gradient.Secondly,