注塑英文工艺名词[宝典].docVIP

注塑英文工艺名词 成型工艺流程及条件介绍 Molding technique procedure and parameter introduction 第一節 成型工艺 Section 1 molding technique. 1.成型工艺参数类型 Sorts of molding parameter. (1). 注塑参数 Injection parameter. a.注射量 Injection rate. b.计量行程 Screw back position c.余料量 Cushion d.防诞量 Sucking back rate e.螺杆转速 Screw speed f.塑化量 Plastic0 rate g.预塑背压 Screw back pressure h.注射压力和保压压力 Injection pressure and holding pressure i.注射速度 Injection speed (2)合模参数 Clamping parameter a.合模力 Clamping force b.合模速度 Clamping speed c.合模行程. Clamping stroke d.开模力 Opening force e.开模速度 Opening speed f.开模行程 Opening position g.顶出压力 Ejector advance pressure h.顶出速度 Ejector advance speed i.顶出行程 Ejector advance position 2.温控参数 Temperature parameter a.烘料温度 Dry resin material temperature b.料向与喷嘴温度 Cylinder temperature and nozzle temperature c.模具温度 Mold temperature d.油温 Oil temperature 3.成型周期 Molding cycle a.循环周期 Cycle time b.冷却时间 Cool time c.注射时间 Injection time d.保压时间 Holding pressure time e.塑化时间 Plant time f.顶出及停留时间 Knocking out and delay time g.低压保护时间 Mold protect time 成型工艺参数的设定须根据产品的不同设置. Molding technique parameter setting differs depending on type of product 第二节成型条件设定 Section 2 Molding parameter Setting 按成型步骤:可分为开锁模,加热,射出,顶出四个过程. Molding steps: mold opening/closing, heating injection and knocking out. 开锁模条件: Mold opening parameter: 快速段中速度 低压高压速度 High-speedmid-speed Low pressure high pressure speed 锁模条件设定: Mold closing parameter setting 1锁模一般分: 快速→中速→低压→高压 Mold closing: high-speed →low-speed →low pressure→high pressure 2.快锁模一般按模具情况分,如果是平面二板模具,快速锁模段可用较快速度,甚至于用到特快,当用到一般快速时,速度设到55-75%,完全平面模可设定到 80-90%,如果用到特快就只能设定在45-55%,压力则可设定于50-75%,位置段视产品的深浅(或长短)不同,一般是开模宽度的1/3. In high-speed section, Mold closing speed depends on type of mold. For two –plate mold it can set quick and even especially quick usually, it set speed within 55-75%. For full-plate mold it set speed within80-90% while using especially high speed it set speed within 45-55% and pressure within 50-75% position distance setting differs depending on the volume of product and