轮机工程英语 （Marine engineering English ）.docVIP

轮机工程英语 02（Marine engineering English 02） 24. Test of spray device. The test of spraying and flushing equipment Ⅲ. Ship piping system integrity, tightness submission terms for the completeness and tightness of the piping system. Please clear the rubbish. 2. Please keep well ventilated and do the gas explosion test. Please keep good ventilation and do the gas explosion test. Please provide us with the finished plan of this system. Please change this dress into water tight construction. Remove the valve piece and check if it is the cut-off valve Disconnect this valve to see is it is a non - return valve. The valve (equipment, accessories) is not inspected by the classification society and needs to be made up. This valve (equipment, accessory) hasnt been affirmed or stamped by the classification society. 7. The diameter of this tube (open position, external coating) is not correct. It must be constructed according to the drawing. The diameter of this branch pipe is not correct. It must be used in accordance with The drawing. 8. The pipe should not pass through the oil tank (water tight compartment, human channel, cable tube) and must be corrected to prevent accidents. This pipe must not pass through from above oil tanks (water - tight compartments, passageways or cables) to prevent any accidents from being unattached. It is too bad that The welding (grinding) is too bad. Where is the pressure gauge? The location of the installation is not reasonable. Where s the pressure the gauge? The installation position is not reasonable. 11. There is no discharge valve installed in this box. Why didnt you fit a drain valve on this tank? This arrangement will inconvenience the operation and maintenance of the future. Such arrangement is inconvenient to the future operation and maintenance. 13. There are many accessories, interfaces, and control boxes on the device without nameplates. Make up for it. There are not any nameplates on so many accessories, connections and control boxes.