一维频域瞬态辐射传输方程的数值模拟及其反问题分析-numerical simulation of one-dimensional transient radiation transmission equation in frequency domain and analysis of its inverse problem.docx

AbstractThe duration of ultra-short pulse laser ranges from picosecond to femtosecond when it propagates in participating media, the magnitude of which is comparable to the time scale of radiative transfer, and therefore the transient radiation effects cannot be ignored. The transient effect of radiative transfer includes the time domain and frequency domain characteristics. Researches have been done relatively thoroughly on the time domain characteristics while the researches of frequency domain characteristics have just started recently. Signals of the frequency domain contain both frequency and phase information. Measurements of frequency domain signals can not only use the continuous light source which cannot be used in time-domain, but also be free of detetctor limitation of time-domain methods. Therefore, this dissertation will focuse on studying the frequency domain effects of transient radiative heat transfer.The Finite Volume Method (FVM) is used to simulate transient radiative transfer in present study. Non-dimensionalization will simplify the formula, and eliminate the effect caused by different units in the calculation. Therefore, non-dimensionalization method is applied before discretization of FVM when solving the Transient Radiative Transfer Equation (TRTE).Numerical method has been applied to the incidence of ultra-short pulse laser to 1-D homogeneous media, and verification of independence of the results on solid angles and control volumes has also been done. Comparison between the results of this paper and the results of time domain analysis converted by Fourier Transform is presented. The influences of material properties and pulse width on transmission signals are also studied. Furthermore, a comparison between incidence of ultra-short pulse lasers to double-layer inhomogeneous slab and single-layer slab has been investigated to verify the correctness of the program. The influence of material properties and the location of interface on transmissi