连续退火工艺对于Nb-Ti-IF 钢性能及再结晶织构的.pdfVIP

连续退火工艺对于 Nb-Ti-IF 钢性能 及再结晶织构的影响 李 锋 吕家舜 敖列哥 文 伟 徐伟军 张清辉 （鞍钢技术中心 鞍山 114001） 摘 要 本文主要研究了热镀锌连续退火工艺对Nb-Ti-IF 钢性能及再结晶织构的影响。利 GLEEBLE-3800 热模 拟试验机对带钢在80m/min 和120m/min 两种带速条件下的连续退火工艺进行了模拟，采用780℃、820℃、860℃、 900℃四种退火温度。用X 射线衍射仪、透射电子显微镜、光学显微镜、电子拉伸试验机对样品的再结晶织构、组 织、第二相粒子及力学性能进行了检测和分析。结果表明退火工艺直接影响退火试样的力学性能、第二相粒子形态、 大小及分布和退火织构。在综合分析以上各种因素的基础上给出了Nb-Ti-IF 钢最佳连续退火制度。 关键词 IF钢 连续退火 热模拟 第二相粒子 再结晶织构 The Influence of Continuum Annealing on the Properties and Recrystallization Texture of Nb-Ti-IF Steel Li Feng Lv Jiashun Ao Liege Wen Wei Xu Weijun Zhang Qinghui (Ansteel Technology Center, Anshan, 114001) Abstract The influence of continuum annealing on the properties and recrystallization texture of Nb-Ti-IF steel was discussed in this article. The experimental thermal simulation machine was used to simulate the continuum annealing at 80m/min and 120m/min steel strip speeds situation, and 780℃、820℃、860℃、900℃ four temperatures was tested. X-ray and TEM were used to examine the samples. It were proved that there were close relationship among the mechanical properties, the second phase’s shape, size and distributing, recrystallization texture and the continuum annealing technique. The steel sheet’s drawability were affected by this relationship. The suited continuum annealing technique was given based on a comprehensive discuss about all factors. Key words IF steel,continuum annealing,thermal simulation,the second phase,recrystallization texture 带钢连续退火在世界上是较先进的冷轧处理工艺，其生产线具有带钢运行速度快、生产效率高、产品品 种多样化、产品质量高、生产成本低等许多罩式退火工艺无法比拟的优势，因此连续退火技术近年来得到了 迅速的发展[ 1 ]，在热镀锌机组中也得到了广泛的应用。 对于连续退火生产IF 钢，国内外很多作者从不同的角度进行了很多研究，如：罩式退火与连续退火之 间的差 [