营盘路湘江隧道C匝道与主线交接段开挖施工与支护专题含有全套图纸可编辑.docVIP

营盘路湘江隧道设计(C匝道与主线交接段开挖施工与支护设计专题) 摘 要 本文通过给定地质资料以及设计通行要求,对湘江营盘路隧道进行了纵、横断面设计;通过工程类比法,分别对不同围岩地质条件下的衬砌结构进行了设计与验算;同时对隧道进行了防排水、施工组织设计并对小净距隧道的施工与支护设计方法作了研究。通过C匝道设计专题,研究了主线与匝道相接段:扩宽大跨度段、连拱段、小净距段的开挖掘进与支护设计方法以及合理施工顺序的安排。同时采用地层结构法,运用软件对整个开挖施工过程以及衬砌结构内力进行模拟,并对各支护参数的影响进行探讨。 关键词:匝道;小净距隧道;大跨度隧道;数值模拟 全套CAD图纸,加174320523 各专业都有 1 TUNNEL DESIGN OF XIANGJIANG YINGPAN ROAD SPECIAL SUBJECT OF EXCAVATION AND SUPPORTING DESIGN IN TRANSITION SECTION OF C RAMP AND MAIN LINE Abstract In this paper, the tunnels cross-section and vertical-section of Xiangjiang Yingpan road were designed, according to the designing requirement of traffic, with a given geological information. Through the engineering analogy method, different lining structures for different geological conditions of surrounding rock were separately designed and the lining structures were also checked accordingly. The tunnels waterproof, portal and construction organization design were also researched, at the same time, the construction and supporting method of small spacing tunnel was studied. In the special design subject of C ramp, the excavation and supporting methods and the reasonable construction sequences of the mainline and ramp connected section were researched, such as, large span section, double-arch section and small spacing section. At the same time, with the stratum structure method , excavation process and lining internal forces were simulated by software, and the influences of supporting parameters were also analysised after then. Key words:Ramp;Large span tunnel;Small spacing tunnel; Numerical simulation 目 录 1 设计资料及要求 1 1.1. 设计资料 1 1.2. 设计要求 1 2 主线隧道纵横断面设计 1 2.1. 隧道纵断面设计 1 2.2. 隧道横断面设计 2 3 主线隧道衬砌结构设计 6 3.1. 衬砌结构设计 6 4 衬砌结构计算 8 4.1. 结构计算 8 5 施工组织设计 25 5.1. 三台阶临时仰拱法施工方案 25 5.2. CD法施工方案 27 6 隧道防排水设计 28 6.1. 设计原则 28 6.2. 防排水设计 29 7 隧道监控量测 32 7.1. 监控量测目的 32 7.2. 监控量测项目 32 7.3. 监测方法 33 8 路面结构设计 36 8.1. 主线隧道