【环氧阻燃电子灌封胶特点】混合粘度的成形工艺.docVIP

【环氧阻燃电子灌封胶特点】混合粘度的成形工艺 Characteristics of epoxy flame retardant electronic potting compound] forming process of mixed viscosity This product is black epoxy potting compound. It has moderate viscosity, good fluidity and easy to permeate into the gap of the product. The forming process is simple; A, B, two components of mixing, the operation time is long, can be cured at room temperature, can also be heating curing, curing speed moderate; Curing surface smooth, no bubbles, has a good gloss, acid and alkali resistance, moisture-proof insulation, curing higher hardness; Curing agent has flame retardant property, good acid and alkali resistance, moisture proof, waterproof, oil proof and dustproof performance, good heat and moisture resistance and air aging; The curing agent has good electrical properties, low shrinkage, high adhesive strength, good cold and heat cycle and air aging. The cured material has good insulation, compressive and adhesive strength, high electrical and physical characteristics. The effect of thermal grease is filled between CPU and radiator and heat conduction gap. Because of the production of sophisticated heat sink and then contact CPU will have some gaps, so we need to fill the gap between the CPU and heat sink using thermal grease. By increasing the contact area of the two, the effect of thermal conductivity is improved, and the temperature of CPU or GPU is too high to be damaged. But it should be noted that, because the conductivity of metal sink than thermal grease is much stronger, so here the use of thermal grease is only used to fill the gap, but not to connect the CPU and heat sink, do not think that is the main heat thermal grease, it just helps heat sink. Electronic UV glue and because the UV is also divided into different bands, so not all ultraviolet rays can be used, but must be the main peak of 365nm ultraviolet it, so that what the mosquito lamp yanchaoji ah, ah, not all. Also, because the sun contains all the light of the band, t