CCNA题库V总结.docVIP

1. Refer to the exhibit. From RouterA, a network administrator is able to ping the serial interface of RouterB but unable to ping any of the subnets attached to RouterB. Based on the partial outputs in the exhibit, what could be the problem? A. EIGRP does not support VLSM. B. The EIGRP network statements are incorrectly configured. C. The IP addressing on the serial interface of RouterA is incorrect. D. The routing protocol has summarized on the classful boundary. E. EIGRP has been configured with an invalid autonomous system number. Answer: D 2. Refer to the exhibit. A junior network engineer has prepared the exhibited configuration file. What two statements are true of the planned configuration for interface fa0/1? (Choose two.) A. The two FastEthernet interfaces will require NAT configured on two outside serial interfaces. B. Address translation on fa0/1 is not required for DMZ Devices to access the Internet. C. The fa0/1 IP address overlaps with the space used by s0/0. D. The fa0/1 IP address is invalid for the IP subnet on which it resides. E. Internet hosts may not initiate connections to DMZ Devices through the configuration that is shown. Answer: BE 3 Refer to the exhibit. The following commands are executed on interface fa0/1 of 2950Switch. 2950Switch(config-if)# switchport port-security 2950Switch(config-if)# switchport port-security mac-address sticky 2950Switch(config-if)# switchport port-security maximum 1 The Ethernet frame that is shown arrives on interface fa0/1. What two functions will occur when this frame is received by 2950Switch? (Choose two.) A. The MAC address table will now have an additional entry of fa0/1 FFFF.FFFF.FFFF. B. Only host A will be allowed to transmit frames on fa0/1. C. This frame will be discarded when it is received by 2950Switch. D. All frames arriving on 2950Switch with a destination of 0000.00aa.aaaa will be forwarded out fa0/1. E. Hosts B and C may forward frames out fa0/1 but frames arriving from other switches will n