AS500012005翻译版.docVIP

Australian/New Zealand StandardTM 澳大利亚/新西兰标准TM Electric cables—Polymeric insulated Part 1: For working voltages up to and including 0.6/1 (1.2) kV 聚合物绝缘电力电缆 第一部分：工作电压0.6/1 (1.2) kV  This Joint Australian/New Zealand Standard was prepared by Joint Technical Committee EL-003, Electric Wires and Cables. It was approved on behalf of the Council of Standards Australia on 28 October 2005 and on behalf of the Council of Standards New Zealand on 4 November 2005. This Standard was published on 17 November 2005. 本《澳大利亚/新西兰联合标准》由EL-003电线电缆技术联合委员会编制，以澳大利亚标准委员会和新西兰标准委员会的名义分别于2005年10月28日和2005年11月4日获得审批通过。 本标准于2005年11月17日出版。 The following are represented on Committee EL-003: EL-003委员会由下列单位组成： Australasian Railway Association 大洋洲铁路协会 Australian Electrical and Electronic Manufacturers Association 澳大利亚电气与电子制造商协会 Australian Industry Group 澳大利亚工业集团 Canterbury Manufacturers Association New Zealand 新西兰坎特伯雷制造商协会 Department of Primary Industries, Mine Safety (NSW) 新南威尔士矿山安全第一产业部 Electrical Contractors Association of New Zealand 新西兰电气承包商协会 Electrical Regulatory Authorities Council 电气监管机构委员会 Energy Networks Association 能源网络协会 Engineers Australia 澳大利亚工程师协会 Ministry of Economic Development (New Zealand) 新西兰经济发展部 Keeping Standards up-to-date 关于标准的更新 Standards are living documents which reflect progress in science, technology and systems. To maintain their currency, all Standards are periodically reviewed, and new editions are published. Between editions, amendments may be issued. Standards may also be withdrawn. It is important that readers assure themselves they are using a current Standard, which should include any amendments which may have been published since the Standard was purchased. 标准是应适时更新的文件体系，反映人们在科学、技术及系统方面取得的进步。为了保持标准的版本最新，所有标准都得定期进行评审并出版新的版本。在刊印不同版本期间，可能还会发行标准的修正内容。标准也可能会被取消。因此，读者使用的版本必须是最新版本，其中应包括在购买标准以来出版的所有修正版本的内容。 Detailed information about joint Australian/New Zealand Standards can be found by visiting the Standards Web Shop at