外文翻译浇注系统形式和浇口设计.docxVIP

英文翻译Gating system design forms and gateA. mainstream design 1. Mainstream Road Size Road end and mainstream is in contact with the nozzle injection machine, and the other end of shunt connected with the taper section of the mobile channel. Road mainstream Xiaoduan size of 3.5 ~ 4 mm. 2. Hub in the form of mainstream Road Road entrance to the mainstream Xiaoduan and repeated contact with the nozzle injection machine, is a consumable, more stringent requirements of the material, thus, part of the mainstream mold often designed as a removable sleeve, the replacement of the mainstream form (commonly known as the gate sets, said here Jack Tsui), in order to effectively separate the selection of high-quality steel processing and heat treatment. Jack Tsui are standard parts, just to buy on the line. Common jack Tsui into a jack Aguilar asked not care jack Tsui and two under the former map, a jack Aguilar asked for compatibility positioning circle. Jack Tsui specifications are Φ12, Φ16, Φ20, such as several. As for the injection nozzles a radius of 20, so jack Tsui for R21. 3. Mainstream, the fixed hub Because the use of a child care jack Tsui, using circle with a fixed location in the mold of the panel. Setting circles are also standard parts, the diameter of Φ120 mm, diameter Φ35 mm. Specific institutional form as shown below: B. shunt design In multi-cavity or multi-cavity gate (plastic pieces of large size) should be set up triage Road, shunt is the mainstream, with the gate between the end of this section of the plastic melt flow channel. It is pouring in molten state system of plastic into the cavity from the mainstream Road, through the cross-sectional area and the changes in the flow of transformation for the smooth transition of the flow pattern. Therefore, should be designed to divert the pressure to meet a good transfer and maintain the ideal state of filling and in the process of movement of pressure loss as possible, can melt plastic balanced distribution to th