采用VFC的压力远程监测装置设计和实验研究.docVIP

重庆大学本科学生毕业设计（论文） 采用VFC的压力远程监测装置设计 和实验研究 学 生：XXXXX 学 号：XXXXXXX 指导教师：XXXXXXX 专 业：机械电子工程 重庆大学机械工程学院 二O一一年六月 Graduation Design(Thesis) of Chongqing University Design and experimental study of VFC remote pressure monitoring divice Undergraduate: Shu Jingchao Supervisor: Prof. Sun Xiaosong Major: Mechanical-electronic engineering Mechanical-electronic engineering Chongqing University June 2011  摘 要 在企业生产过程中，及时准确地得到压力参数对生产管理，产品质量，生产安全等方面具有重大意义。由于各种原因，我们也许不可能在现场对压力参数进行测量和监测，因此压力的远程监测显示的十分重要。本文论述了基于VFC数模转换装置，以AT89C52为核心的压力远程监测系统硬件和软件设计。该系统硬件主要模块包括：信号采集、信号放大、信号转换、数字信号远程传输、数字信号处理、结果显示、报警电路、看门狗电路等模块。传感器的输出的电压信号经过电压运放输入到VFC进行数模转换，然后输出频率信号，经市话网传输到终端AT89C52单片机进行处理、显示、报警等操作。本系统的软件设计，以C语言为开发工具，进行详细设计和编码。总的目标是实现系统的可靠性、稳定性、安全性和经济性。 关键词：单片机，VFC，压力，远程监测 ABSTRACT In production , access to accurate and timely pressure parameters on production management , production quality and production safety is of great significance. For various reasons , we may not be possible to monitor and measurement the pressure parameter in site. Therefore , the remote monitoring of pressure is important. This article discusses the VFC-based digital-analog conversion ,AT89C52 as the core of the pressure to remote monitoring system and software design. The hardware system include the main modules: signal acquisition, signal amplification, signal conversion, digital signal long-distance transmission, digital signal processing, the result showed and alarm circuit, the watchdog circuit module. After the sensor output voltage of the op amp voltage signal into VFC to digital-analog conversion,and output frequency signal.Then the frequency signal is transmitted to the terminal SCM AT89C52 to display alarm and other operations. On the system software design, the development tool is C language , a detailed design and coding. The allover object is to achieve system reliability, stability, security and economy. Key words： SCM ,VFC, Pressure, Remote Mon