注塑机的动态模拟业课程设计外文文献翻译.docxVIP

附录A Dynamic Simulation of an Injection Molding Author1, Author2, Author3. Applied Thermal Engineering, 2016, 8(6):556-568. Abstract: An integrated design method is discussed which thoroughly considers related parameters of the various subsystems in order to optimize the overall system that mainly consists of opto--mechanical structure CAD, CAE and the integrated information platform PDM. Based on the parameter drive of the virtual main model, the method focuses on the model transformation and data share among different design and analysis steps, and so the concurrent simulation and design optimization are carried out. As an example of application, the integrated design for a large-scale opto-mechanical structure is introduced, including optical design, structure design and analysis, which further validates the advantages of the method. Due to comprehensive consideration of the design and analysis process by CAD and CAE based on PDM, the integrated design well attains the structure optimization with high efficiency. Keywords: integrated design; CAD/CAE; large-scale structure; optical instrument. 1. Introduction The analysis of products integrating different technologies, e.g. mechanical, hydraulic and controls systems, becomes more and more feasible with the constant development of simulation software and more performing computer hardware. The combination of specialized software packages is possible and allows the simulation of so-called mechatronic systems. If in the past such tools were mainly used in the aeronautic and automobile industries, they now find their way into more common engineering applications. In this case,the dynamic characteristics of the clamp unit of an injection molding machine from HUSKY is investigated. For this purpose, the finite-element (FE) program ANSYS, the multi-body simulation (MBS) software ADAMS, the fluid power simulation software DSHplus and the controls design tool MATLAB/Simulink are used. Combining these different simulation too