基于有限元分析日光温室土质墙体温度场模拟与验证.docVIP

基于有限元分析日光温室土质墙体温度场模拟与验证.doc

  1. 1、原创力文档(book118)网站文档一经付费(服务费),不意味着购买了该文档的版权,仅供个人/单位学习、研究之用,不得用于商业用途,未经授权,严禁复制、发行、汇编、翻译或者网络传播等,侵权必究。。
  2. 2、本站所有内容均由合作方或网友上传,本站不对文档的完整性、权威性及其观点立场正确性做任何保证或承诺!文档内容仅供研究参考,付费前请自行鉴别。如您付费,意味着您自己接受本站规则且自行承担风险,本站不退款、不进行额外附加服务;查看《如何避免下载的几个坑》。如果您已付费下载过本站文档,您可以点击 这里二次下载
  3. 3、如文档侵犯商业秘密、侵犯著作权、侵犯人身权等,请点击“版权申诉”(推荐),也可以打举报电话:400-050-0827(电话支持时间:9:00-18:30)。
  4. 4、该文档为VIP文档,如果想要下载,成为VIP会员后,下载免费。
  5. 5、成为VIP后,下载本文档将扣除1次下载权益。下载后,不支持退款、换文档。如有疑问请联系我们
  6. 6、成为VIP后,您将拥有八大权益,权益包括:VIP文档下载权益、阅读免打扰、文档格式转换、高级专利检索、专属身份标志、高级客服、多端互通、版权登记。
  7. 7、VIP文档为合作方或网友上传,每下载1次, 网站将根据用户上传文档的质量评分、类型等,对文档贡献者给予高额补贴、流量扶持。如果你也想贡献VIP文档。上传文档
查看更多
基于有限元分析日光温室土质墙体温度场模拟与验证

基于有限元分析日光温室土质墙体温度场模拟与验证   摘 要:研究日光温室墙体中温度梯度及其变化规律对于日光温室墙体的蓄热保温性能分析评价、设计与建造有着重要的意义。2012年12月至2013年2月,采用自制多点温度测试仪,对山东泰安地区日光温室土质墙体的温度进行采集,并与ANSYS有限元模拟结果进行比较,发现温度场实测结果与模拟结果相吻合。进一步模拟结果表明,墙体蓄热/放热层一天中呈周期性变化,保温隔热层随外界温度变化较小,墙体下部温度较高,且在水平方向上温度梯度变化较小,在10~14℃持续时间长且稳定;距墙体内表面0.2 m处温度最高,并沿墙体厚度方向逐渐平缓降低,墙体外表面温度最低。基于模拟结果,对山东省泰安地区日光温室土质墙体进行结构优化,其最小厚度应为2.2 m,蓄热/放热层为0~0.5 m,保温隔热层为1.3~1.7 m。   关键词:日光温室;土质墙体;ANSYS模拟;温度场;泰安地区   中图分类号:S625.1 文献标识号:A 文章编号:1001-4942(2014)04-0007-06   Simulation and Verification of Greenhouse Soil Wall Temperature Field by FEM Analysis   Hou Jialin1,Wang Tao1,Jiang Tao1,Wang Xiufeng2*   (1.College of Mechanical and Electronic Engineering, Shandong Agricultural University, Taian 271018, China;   2. College of Horticulture Science and Engineering, Shandong Agricultural University, Taian 271018, China)   Abstract It was significant to study the temperature gradient and its change rule for evaluation of heat prevention performance, design and construction of greenhouse wall. The temperature data of greenhouse soil wall in Taian region were measured through multi-point temperature test instrument from December 2012 to February 2013. The measured results coincided with that obtained through ANSYS FEM simulation. The further simulation results showed that the temperature of heat release and absorption layer in the wall changed periodically in a day, while that of heat preservation and insulation layer changed smaller. The temperature at the wall bottom was higher, and changed a little in the horizontal direction, which was stable at 10~14℃ for long time. The temperature was the highest at the place 0.2 m away from the inner surface of wall, and reduced gently along the direction of wall thickness; the outer surface of the wall had the lowest temperature. Based on the simulated and measured results, the optimized soil wall of greenhouse in Taian area showed that the minimum thickness should be 2.2 m, including 0~0.5 m of heat release and absorption layer and 1.3~1.7 m

文档评论(0)

erterye + 关注
实名认证
文档贡献者

该用户很懒,什么也没介绍

1亿VIP精品文档

相关文档