MS7简介.pptVIP

MS7 introduction -----------祝文林 Email：wenlinzhu@ 2007.1.9 MS7叙述 MS7 illustration MS7共有48pin；MS7 contains 48pins totally. MS7可以直接或间接转出8个电压信号（但不一定都会用到）；MS7 can transfer out 8 voltage signals directly or indirectly (however not every is available ) MS7共有4个reset buffer；MS7 embodies 4 reset buffers. MS7共有3个POWGD buffer（power good schmitt trigger）。MS7 holds 3 power buffer. 通过BIOS可以调节MS7两个电压（RAM and AGP）； We can coordinate the two voltages of MS7( RAM and AGP) through BIOS . MS7 logic blocks 为了能更清晰的了解MS7的function,先来看看下面这幅POWER MAP. Aim to understand MS7’s function more clearly ,Let’s have a look at the below Power Map. 下面我们根据前面所介绍的MS7各个功能来看看他们是怎么工作的。尤其是了解通过它转化出的各个电压。 The following, on basis of above illustrated MS7’s functions ,Let’s explore how them operate and especially learn the various voltages transited through MS7. 1、rsmrst#（Resume reset） 在S5状态的时候，MS7根据所转化得到的3VSB电压而产生。从时序上看，它应该是位于3VSB之后起来。这个信号与5VSB和3VSB信号相关。In S5 status, it’s generated by MS7 through 3VSB.in the view of time sequence , it rises up behind 3VSB and is related with 5VSB and 3VSB. 请注意：这个pin为OD型，因此，必须pull high。 NOTE: this pin is of OD pattern , hence ,must be pulled to a high condition. 2、ss（soft start） 该动作发生在S5状态。Such action is occurred in S5 status. 软启动用于防止产生3VSB时的暂态电流过大，从而损毁IC；另外还通过一个外接的电容（一般为0.22uF，20～30ms）负责调节3VSB的上升timing。 Soft start is intended to prevent over temporary current when 3VSB comes up from damaging IC ,and additionally adjust rising time of 3VSB by a externally jointed capacitor (normally 0.22uF,20~30ms) 3、charge pump（电荷泵） S5 状态时开始有效。通过C1与C2之间的一颗电容进行倍压，从而把5VSB倍压为9VSB电压。9VSB可以为MS7的多个pin提供电源。 It comes to force in S5 status. Double 5VSB to 9VSB through a compactor between C1 and C2,9VSB could provide power to more than one pin of MS7. 4、S3#和S5#（