无机聚合物混凝土温度-应力试验分析-analysis on temperature-stress test of inorganic polymer concrete.docxVIP

武汉理 武汉理工大学硕士学位论文 万方数据 万方数据 面温度增长较慢；混凝土中心温度及外表面温度温差较大；达到温峰值后，混 凝土中心温度降低，外表面温度有小幅度增加，中心温度与外表面温度温差减 小。 关键词：无机聚合物混凝土，温度应力，试验研究，开裂敏感性，有限元分析 III Abstract With the growth of our country’s economy, urban construction develops rapidly and the construction industry is increasing demanded. However our country is now in the situation of variety of resources shortage and serious environmental pollution. Global warming and the invasion of haze have a negligible impact on peoples daily lives. This prompted us to look for new environmentally materials, and apply it to all walks of life. Inorganic polymer material becomes a new material that scientists today are more concerned about by its low cost, low pollution, resource-rich and excellent performance. A lot of tests have been done to study of the basic mechanical properties and durability of inorganic polymer concrete. We have achieved fruitful research results and basically mastered the key technology of preparation of inorganic polymer concrete. However, the relevant thermodynamic property of the inorganic polymer concrete is scarce. In this paper, basis on a large number of experiments and theory, the temperature field and stress field after pouring of inorganic polymer concrete materials have been studies. The main research work and significant achievements are as follows: Trends of deformation, elastic modulus and temperature with age of inorganic polymer concrete after pouring is discussed. It is roughly similar to normal concrete. After pouring, all experienced early contractions to swell, then shrink to the cracking. Elastic modulus increased gradually with age. As the hydration of inorganic cementitious materials, the concrete’s internal temperature rises, then as the heat exchange with the air, the temperature decreases. In the case of bound inorganic polymer concrete generated smaller compressive stress early. When the concrete shrinkage stress gradually transformed into tensile stress until tensile stress subjected is