Anderson挤出机.pptx

Anderson挤出机“Process Control Requirements”?“工艺控制要求” The crumb slurry from the final wash tank must be drained of “free water” prior toentering the Expeller? hopper. If excess free water is permitted to enter the Expeller?hopper it can cause an upset condition in the overall dewatering and drying functions. Free water drainage is typically done with a vibrating conveyor designed with a profile wire deck, which will allow the free water to drain through to a drainage troughmounted below the profile wire deck.从胶罐出来的橡胶於浆在进入挤出机的漏斗之前，必须要脱除“游离水”。如果过量的游离水进入挤出机的漏斗，可能造成扰乱所有的脱水和干燥功能的条件。游离水排出的典型方式是通过震动筛完成，这个设备允许斜面金属筛板将大量的水排出。 The crumb entering the Expeller? hopper must be occasionally analyzed to ensure that the level of VM (volatile matter) bound in the rubber crumb is maintained within the acceptable range required for “mechanical dewatering”. At this point VM% should be maintained between 40 to 60% by weight.胶粒进入挤出机的漏斗必须定期分析，以确保VM（挥发性物质）的水平限定在橡胶处理可以接受的范围之内，这个范围是机械脱水的要求。这个点VM%应该保持在40—60%的重量比。 Just as in the feed stream to the Expeller?, the crumb entering the Expander/Dryer?hopper must be occasionally analyzed to ensure that the level of VM (volatile matter) bound in the rubber crumb is maintained within the acceptable range required for “mechanical drying”. The typical range for VM% in the crumb at the Expander/Dryer feed hopper is 8 to 12%. This can change to a degree between polymer types and capacity.正如挤出机的进料，橡胶进入膨胀机漏斗也需要定期分析VM（挥发性物质）的水平，确保VM的水平控制在橡胶处理可以接受的范围之内。膨胀机进料漏斗处橡胶的典型VM%含量范围是8-12%，这个数值可以根据聚合物的类型和能力而改变。 As the heated crumb “explodes” through the Expander/Dryer? die plate the pressure drop to ambient causes the VM to go from a liquid to a gas. At this point residual levels of VM in the porous crumb are typically 1 to 2%. Additional residence time downstream of the Expander/Dryer? is required to evaporate any residual moisture left in the product.通过在膨胀机出口模头处，压力降低为常压，致使VM从液态变为气态而脱除，好像加热橡胶“爆炸”。在这个点，在多孔状的橡胶里面VM含量水平的典型值是1-2%。在加上膨胀机下游的停留时间，要求将产品中残余湿气蒸发。 At the discha