TCR支路损耗研究-电气工程专业论文.docxVIP

II II 件的仿真和控制部分仿真两大部。电力器件的仿真可细分为 500kV 侧电网 的简化仿真和 SVC 仿真模型（换流变压器仿真模型和 TCR 支路仿真模型以 及固定电容器组仿真模型）；SVC 控制部分仿真包含母线电压测量仿真模型、 SVC 有功、无功测量仿真模型、PI 控制器仿真模型、晶闸管导通角计算、 触发脉冲模块仿真等。通过仿真验证上述推导出公式的合理性。 关键词：晶闸管阀组 通态损耗 阻尼损耗 电抗器损耗 RTDS 仿真 III III THE STUDY ON LOSS OF TCR BRANCH ABSTRACT After the cold rain and snow freeze disaster 2008 a 500 kV substations installed dc melting ice and SVC (Static Var Compensator) device. After the 500 kV substation measuring known TCR loss is bigger, because no network loss calculation of thyristor valve at home and abroad industry standard , IEEE Std 1031-2011 for equipment type selection reference of the loss of thyristor valve group, with thyristor valve group of actual loss value gap is bigger, not as a loss of substation computing thyristor valve group standards. In this paper the thyristor valve group and the loss of reactor were studied. This paper proposes a new algorithm for the thyristor valve group on state loss.The new algorithm using a more precise thyristor voltage drop model, new formula of thyristor valve on state loss calculated value significantly lower than the recommended by IEEE Std 1031-2011 loss of thyristor valve group conducting state formula calculated value, so the new algorithm improves a lot than the IEEE Std 1031-2011 recommended formula. The thyristor valve group damping loss formula for the theoretical derivation, find out the thyristor valve group of damping loss causes of deviation. For thyristor valve group blocking state loss is small, the domestic and foreign literature and the related standard only mentioned the thyristor valve group blocking state loss less ,no points out that the blocking state loss calculation formula.This paper obtained by theoretical derivation formula of blocking state loss, with a example confirmed that the blocking state loss less than 230 W. For reactor loss another calculation formula is deduced, the calculation method of using reactor’s the average current and the loss of IEEE Std 1031-2