UHF RFID牛耳标的设计与工艺研究-材料加工工程专业论文.docxVIP

华中科技大学硕士学位论文 华 中 科 技 大 学 硕 士 学 位 论 文 II II Abstract Common cattle ear tags with QR code have many defects such as small storage information, short read range, unchangeable storage information, vulnerable to environmental pollution, inconvenient, poor anti-false performance etc, therefore cant meet the requirements of large-scale modern farming and food safety traceability system. In contrast, UHF RFID has more advantages, such as multiple targets fast recognition, dynamic identification, farther read range, good security performance, EEPROM, compatible with ERP system etc, and is very suitable for animal identification and management. Therefore, this paper chooses cattle ear tags built-in UHF RFID label to be studied. This paper designs and optimizes a folded dipole antenna based on a NXP G2XL chip by HFSS simulation analysis software, which used to fabrication UHF RFID ear tags for cattle. The antenna combinates the T match and the end capacitive load method, easily realizes the impedance match and easily adjusts the size. Measured by the sample preparation, the read range is in 3m above, achieving the requirements of the UHF RFID industry application. This paper makes RFID antenna on the PI film by nanometer ink-jet printing, which is quick and efficient. The resistance ratio of antenna has achieved RFID industry application requirements. The research and implementation of the process is helpful to short the proofing cycle of RFID tag antenna. This paper designs an utility ear tag for cattle with chimeric- welded structure,which has lower cost and higher efficiency. Furthermore, there is no damage to the built-in tags in the whole welding process. This paper builds a simple UHF RFID read range testing platform,tests and analysis the read range of label before and after packaged.Test finds that whether packaged, there is recognition blind area in the read range of label.What’s more, the attenuation of the III III read range of label after packaged is up to 36%.This