对瓷贴面不同粘结层的三维有限元应力分析-口腔临床医学专业论文.docxVIP

解放军医学院硕士学位论文 解放军医学院硕士学位论文 万方数据 万方数据 An Analysis of Different Bonding Layer on Porcelain Laminate Veneers by Three-dimensional Finite Element Stress Abstract Objectives: The paper aims to provide theoretical basis for clinical application by using the software to generate the 3D solid model and the 3D finite element model of the lower central incisors, and by biomechanical analysis of the stress on the porcelain laminate complex adhesive layer. Methods: The dental raw data is obtained by Micro-CT, to file the image into Mimics10.01 software, in order to generate the 3D solid model and the 3D finite element model of the lower central incisors by topo algorithm and ANSA software. With the finite element method analysis of the stress distribution of porcelain laminate complex adhesive layer with different thickness under different loading conditions, and to solve the model using the ABAQUS/Standard solver, and stress analysis. Results: The precise 3D solid model and 3D finite element model of the lower central incisors are achieved. The stress nephogram shows: for the vertical loading, Von Mises stress is mainly concentrated on the tongue far in 1/3 and the cut ends of the adhesive layer in 1/3. For the oblique loading, Von Mises stress is mainly concentrated on the labial surface cut end distal 1/3 and lingual cervical distal 1/3. Von Mises stress of oblique loading is always more powerful than the one of vertical loading; when the adhesive thickness is 100um in different loading conditions, Von Mises stress has the minimum power. Conclusion: The focus of mandibular central incisors porcelain veneer restorations is the edge of the cut ends of the adhesive layer, and to guide the extension of the mandibular teeth long axis under stress. When the thickness of the adhesive layer is around 100um, it is more conductive to the bonding effect of porcelain veneer. 2 Key words：mandibular central incisors; Micro-CT; porcelain laminate veneer; finite element analysis; stress dist