数显简易计算器.docVIP

/********************************************************************* 可以连算不需反复清零，但每次输入参数后必须输入等于此问题有待解决.立编 *********************************************************************/ #includereg52.h #define uchar unsigned char uchar a0=16,b0=16,c0=16,d0=16,e0=16, s0,s1,s2,s3,s4,s5, f0=16,wei,temp,key,i,j,k,jian0,jia0,cheng0,chu0; uchar jia,jian,cheng,chu,dengyu,qingling,yunsuan; unsigned long num,M; sbit dula=P2^6; sbit wela=P2^7; sbit beep=P2^3; unsigned char code table[]={ 0x3f,0x06,0x5b,0x4f,0x66,0x6d, 0x7d,0x07,0x7f,0x6f,0x77,0x7c, 0x39,0x5e,0x79,0x71,0x00}; void delay(uchar i) { for(j=i;j0;j--) for(k=125;k0;k--); } void display(uchar a,uchar b,uchar c,uchar d,uchar e,uchar f) { dula=0; P0=table[a]; dula=1; dula=0; wela=0; P0=0xfe; wela=1; wela=0; delay(5); P0=table[b]; dula=1; dula=0; P0=0xfd; wela=1; wela=0; delay(5); P0=table[c]; dula=1; dula=0; P0=0xfb; wela=1; wela=0; delay(5); P0=table[d]; dula=1; dula=0; P0=0xf7; wela=1; wela=0; delay(5); P0=table[e]; dula=1; dula=0; P0=0xef; wela=1; wela=0; delay(5); P0=table[f]; dula=1; dula=0; P0=0xdf; wela=1; wela=0; delay(5); } void keyscan() { P3=0xfe; temp=P3; temp=temp0xf0; if(temp!=0xf0) { delay(10); if(temp!=0xf0) { temp=P3; switch(temp) { case 0xee: key=1; wei++; break; case 0xde: key=2; wei++; break; case 0xbe: key=3; wei++; break; case 0x7e: jia=1; break; } while(temp!=0xf0) { temp=P3; temp=temp0xf0; beep=0; } beep=1; } } P3=0xfd; temp=P3; temp=temp0xf0; if(temp!=0xf0) { delay(10); if(temp!=0xf0) {