利用PMTDPS测量氩等离子体多次冲击状态-f.DOCVIP

- PAGE 8 - Thermophysical properties of multi-shock compressed dense argon Q. F. ChenaElectronic mail: chenqf01@; chen_qifeng@,a, J. Zheng, Y. J. Gu1, Y. L. Chen1, L. C. Cai1 aElectronic mail: chenqf01@; chen_qifeng@ 1National Key Laboratory of Shock Wave and Detonation Physics, Institute of Fluid Physics, P.O. Box 919-102, Mianyang, 2Laboratory of computational Physics, Institute of Applied Physics and Computational Mathematics, P O Box 8009-26, Bejing 10086 Supplemental Material 1. The determination of the multi-shock states In order to address the issue on determining multiple shock compresion states, we show the shock impedance matching solution for the first- to fourth-shock states in experimental shot GAr429, which can be analyzed with the aid of the pressure-particle velocity(P-up) diagram shown in Supplemental Figure 1. The gas argon is confined in a cell with a 304 steel baseplate at the impact end and a LiF-1/LiF-2 /Al2O3 composite window at the other end. The shocked state of the baseplate was determined using the known equation of state of the Ta flyer and the steel baseplate, and the measured flyer velocity. A graphical representation of the impedance matching method is shown inset in Supplemental Figure 1. The initial shock state of the steel baseplate is described in the pressure-velocity P-up plane by the point labeled 0, which corresponds to the intersection of the steel baseplate and the Ta flyer Hugoniots. The shock state of the gas Ar is constrained to lie on the straight line of slope , where is the initial density of the gas Ar sample. The u1,Ar of the gas Ar is determined by the intersection of the baseplate release isentrope from state 0 and the line defined by the shock impedance of the gas Ar, indicated by point 1. The initial shock generates P-up state 1 on the principal Hugoniot of the sample. The shock traverses the sample and reflects off the LiF-1 window, producing P-up state 2, the intersection of the LiF Hugoniot with the first A