等离子坡口弧压控制的设计-控制工程专业论文.docx

西南科技大学硕士生学位论文第 西南科技大学硕士生学位论文 第 Ⅱ 页 Abstract Plasma Bevel Cutting Machine is a very popular blanking machine with high technology since 2008.It has great advantage in cutting speed,cutting precision,saving pre-welding prepared time,The other bevel cutting equipment can not reach it.With the computer technique and motion control technique growing up.More and more Plasma Bevel Cutting Machine has walked into Steel Structure Company.From the Plasma Cutting technique was has been invited,generation after generation of the Plasma Cutting Machines makes people much easier to cut steel like a tailor cut cloth.So the Plasma Bevel Cutting Machine with modern technique was called as Steel Tailor Bevel Arc Height Control was a very important parts to the Bevel Plasma Cutting Machine.Unfortunately now the control methods can not make the very high precision control ， The foreign equipment is very expensive and not used well,The domestic equipment is almost blank This paper designed the control scheme based on analysis of the plasma are principles and analysis of arc voltage collected data.We make the high precision motion control by motion card with DSP motion control chips.Write control software,open the control parameters interface,and experimental verification of the correctness of control logic. Actual accurary of cutting height and arc voltage to adjust the cutting height.Finally made a real machine debugging.The difficulties of this design are how to use the correct control strategy and the collecting of arc-height data. Key words: Plasma arc; Plasma Bevel Cutting Machine;Bevel Arc Voltage Height Controller；motion control 西南科技大学硕士生学位论文第 西南科技大学硕士生学位论文 第 Ⅳ 页 目录 目录 1 1 绪论 1 1.1 平板坡口等离子切割机介绍 1 1.2 研究的课题来源，目的与意义 1 1.2.1 来源 1 1.2.2 目的与意义 1 1.3 同类研究国内外现状与发展趋势 2 1.3.1 国外现状 2 1.3.2 国内现状 4 1.3.3 发展趋势 5 1.4 论文主要的研究内容 5 本章小结 5 2 内置式弧压高度控制器设计方案 6 2.1 系统总体方案 6 2.1.1 等离子切割机组成部分及其功能 6 2.1.2 弧压调高控制方案 7 2.2 等离子弧原理 8 2.2.1 驱动电机比较与选型 9 2.3 系统的功能及性能指标 10 2.3.1 系统所达到的功能 10 2.3.2 系