选择最佳工具，几何形状和切削条件利用表面粗糙度预测模型端铣外文翻译.docVIP

毕业论文中英文资料外文翻译文献 附录 附录1: 英文原文 Selection of optimum tool geometry and cutting conditions using a surface roughness prediction model for end milling Abstract Influence of tool geometry on the quality of surface produced is well known and hence any attempt to assess the performance of end milling should include the tool geometry. In the present work，experimental studies have been conducted to see the effect of tool geometry (radial rake angle and nose radius) and cutting conditions (cutting speed and feed rate) on the machining performance during end milling of medium carbon steel. The first and second order mathematical models，in terms of machining parameters，were developed for surface roughness prediction using response surface methodology (RSM) on the basis of experimental results. The model selected for optimization has been validated with the Chi square test. The significance of these parameters on surface roughness has been established with analysis of variance. An attempt has also been made to optimize the surface roughness prediction model using genetic algorithms (GA). The GA program gives minimum values of surface roughness and their respective optimal conditions. Introduction End milling is one of the most commonly used metal removal operations in industry because of its ability to remove material faster giving reasonably good surface quality. It is used in a variety of manufacturing industries including aerospace and automotive sectors，where quality is an important factor in the production of slots，pockets，precision moulds and dies. Greater attention is given to dimensional accuracy and surface roughness of products by the industry these days. Moreover，surface finish influences mechanical properties such as fatigue behaviour，wear，corrosion, lubrication and electrical conductivity Thus，measuring and characterizing surface finish can be considered for predicting machining performance. Surface finish resulting from turning operations has traditionally received