金属加工厂10KV变电站电气主接线系统设计.docVIP

金属加工厂10KV变电站电气主接线系统设计 西南科技大学城市学院本科毕业论文 I 金属加工厂 10KV变电站电气主接线系统设计 摘要:本次设计攀成钢金属加工厂的供电系统，在满足工厂供电设计中安全、可靠、优质、经济的基本要求的前提下，本文首先根据全厂和车间的用电设备情况和生产工艺要求，进行了负荷计算，通过功率因数的计算，进行无功补偿设计（包括无功补偿容量计算和补偿设备选择、校验），确定了攀成钢金属加工厂的供电方案，通过技术比较，确定了供电系统的主接线形式，选择了主变压器的台数和容量。其次，本文设计了厂区供电和配电网络，选择了合适的导线和电缆，通过合理设置短路点，进行正确的短路电流计算，进行了主要电气设备的选型和校验。 关键词：供电系统； 负荷计算； 主变压器； 设备选择 西南科技大学城市学院本科毕业论文 II Metal processing 10KV substation electrical main wiring system design Abstract: The design of a climbing plant of the power supply system of metal into steel, power plant design to meet safety, reliability, quality, basic requirements of the economy under the premise of this paper, based on all electrical equipment factory and workshop conditions and manufacturing process requirements, for a load calculation, by calculating the power factor, reactive power compensation design (including reactive power compensation capacity calculation and compensation equipment selection, calibration), climbed into steel metal processing plants to determine the power supply program, through technical comparison, the main power supply system to determine the wiring in the form, select a main transformer station number and capacity. Secondly, the paper design of the power plant and distribution network, select the appropriate wire and cable, through a rational set short circuit, short circuit current calculation correctly, were the main electrical equipment selection and validation. Key words: power system， load calculation ，transformer equipment selection 西南科技大学城市学院本科毕业论文 III 目 录 第一章 原始资料分析 ............................................................................................... 1 1.1 厂区总平面布置图 ......................................................................................... 1 1.2 供电电源情况 .................................................................................................