基于fpga的sdh复用与解复用的设计-电路与系统专业论文.docxVIP

ABSTRACTABSTRACT ABSTRACT ABSTRACT In 1 984，the Synchronous Optical Network was proposed to eliminate mutually exclusive of the light interface，and it Was marked as a kind of brand—new transmission network technology system．In 1988，the International Telecommunications Union Standards of International Telex-tdephone Consultation Committee approved the concept，and SCONT Was renamed as Synchronous Digital Dystem(SDH)，at the same time．By constant development and improvement，SDH was recognized as the unified standard of the transmission network．It Was applicated mainly in optical fiber eommtmication，microwave communication and satellite communications，and became the generic technology system．The dements of SDH are rather complex， SO does the agreements and stmcture． Because of causations above， ASIC is the trend of evolution，core circuits of SDH elements are implemented by ASIC． The paper provides the solutions of SDH synchronous multiplexing，and the realization of multiplexing in FPGA．The design includs the STM-1 signal multiplex modules and the scanning tunneling microscopy STM·-64 by STM·-64 interpolation points out STM一1 module．The design could be made as a new device module，and reduce the cost of SDH equipment． This Paper first introduces the principle，analyses the SDH technology index，and affords the way of multiplexing and demultiplexing，After that，it verifies the viability of design in the FPGA developing board．The detection signal is verified through a special DS3 chip and DS3 multiplexed STM一1，via the modules eventually gets DS3 signal．Besides the short design cycle，low cost，according to actual needs，the test design could be put the parts of the special chip． The design divids into the several modules．If not require the high rate signls，mey Can only choose the low rate signals，then the high rate of signal is retained．With the system upgrading，the high speed signals call directly be uesd，in order to meet the needs． Keywords：SDH，STM-N，FPGA，parallel scrambler Ⅱ 独创