基于fds升温曲线的轴压柱等效火灾荷载计算-防灾减灾工程及防护工程专业论文.docxVIP

华 华 中 科 技 大 学 硕 士 学 位 论 文 II II Abstract The building fire is very dangerous because of high frequency and serious loss. More and more people pay attention to anti-fire performance of reinforced concrete members or structures with highly application. The results show that, environmental temperature is confined by many factors, and the structure calculation of resistance to fire sometimes has large difference under the condition of applying IS0834 standard warming up curve uniformly and it cant truly reflect structure response of resistance. In this paper, we can obtain the actual temperature curve by using the FDS to simulate the indoor fire, as the boundary conditions of temperature field finite element analysis of structures. Another way about concrete structure fire resistance design is introducedequivalent fire load .It is a new design method with consideration of the unity of the high temperature and earthquake/snow/wind acted on structural. Firstly, using the FDS to simulate fire development of single room, get the environment temperature curve. With actual temperature curve as the third kind boundary condition and finite element analysis software ANSYS, calculate the component section temperature field distribution, to provide the basis of simplified calculation of equivalent fire load; By using the foregoing theory and numerical analysis, put forward specific equivalent fire load of the simplified calculation method of further modification of the existing formula, all subject to the pillar of example analysis show that the simplified formula is reasonable. The main conclusions are as follows: the indoor temperature of the each point is in the rising over time with the fire development. location, open state, fire source position and size have an impact on the temperature rising the curve of actual, the structure fire resistance design standards are used in heating curves as the ambient temperature is not science, either is not accurate. The component tempera