基于abaqus有限元的粗糙表面滚动接触分析-机械设计及理论专业论文.docxVIP

西安 西安理工大学硕士学位论文 I II I I Abstract Title:ROUGH SURFACE ROLLING CONTACT BASED ON ABAQUS FINITE ELEMENT METHOD Major：Mechanical Design and Theory Name：Ting Zhang Signature: Supervisor: Associate prof. Pengfei Li Signature: Abstract Rough surface contact exists widely in all kinds of mechanical system and has great important influence on friction, wear, lubrication, heat conduction and fatigue life of the component etc of the contact surface. From the macroscopic view, contact surface between the parts are often considered as smooth. But actually, there is awalys a certain roughness in engineering surface. Under the condition of the micro scale, the mechanical characterastics of material will change greatly when roughness of the surface are taken into account. Several methods, such as the Mid-Point Dispalcement method、Inverse Fourier Transform method and Weinerstrass-Mandelbrot method, were used to simulate fractal rough surface profile. Based on finite element software ABAQUS, a two-dimensional rough surface model of rolling contact was established. Three factors, which were different fractal dimension, external load and the tangent modulus, were applied to analyse the influence on contact characteristics. The simulation results were shown as: The larger the fractal dimension, the more convex peaks in the rough surface. These small convex peaks could produce easily the plastic deformation. The contact pressure of rough surfaces would become bigger when rough surface contacted with roller, and the contact stiffness would become smaller. While, the deformation of contact surface would become faster. For different fractal dimensions and material parameters, the relationship between contact pressure and contact load was linear even if rough profiles had produced obviously plastic deformation. The smaller tangent modulus of material, the greater the residual deformation of contact surface. Under the same condition of load, the bigger tangent modulus, the smaller plasti