环模开裂的解决方法.docVIP

环模开裂的解决方法 Ring Die Crack Solutions 不正确的使用和操作办法很容易造成颗粒机环模开裂，影响了正常的生产，下面我们来共同分析一下颗粒机环模开裂的各种原因及解决办法。 Improper usage and operation will easily lead ring dies to crack, this will influence normal production, now we analyze the ring die crack reasons and solutions. 当抱箍工作面有道向光亮点以及传动轮工作面有磨损痕迹，这时抱箍内卡已磨损或变形而造成环模开裂。 When ring die holders working face has been loose and the driven wheel working face has worn out, that means the ring die holders inner part has been worn out or out of shape, and lead to ring dies crack. 解决办法：必须及时更换抱箍。 Solutions: have to replace ring die holders asap. 由于传动轮配合面磨损，模、辊配合面明显松动而造成环模开裂。 Due to driven wheel fitting surface worn out, ring die and roller fitting surface have obvious loose and lead to ring die crack. 解决办法：必须及时更换传动轮或修复，或者增大环模装配面配合尺寸公差。 Solutions:have to change driven wheel or repair, or enlarge the ring die assembly surface to fit the tolerance. 由于压模衬圈磨损或变形而造成环模开裂。 Due to press die lining worn out or out of shape, lead to ring die crack. 解决办法：必须及时检查和更换压模衬圈。 Solutions: have to check and replace press die lining. 由于传动键磨损而导致环模撞击开装。逮时与传动轮松也有关系，定期测量键与键槽的间隙，及时更换传动键。 Due to driven key worn out and lead to ring die crack. It also has relation with driven wheel loose, measure the key and key groove gap regularly, and change driven key asap. 由于主轴轴承损坏，主轴跳动而导致环模开裂。 Due to main shaft bearing broken, main shaft shakes and leads to ring die crack. 解决办法：及时更换主轴轴承。 Solutions: should change the main shaft bearing asap. (6)由于蝶形弹簧弹性没毂紧，使主轴晃动而导致环模开裂。 Due to S spring loose, lead to main shaft shake and then ring die crack. 解决办法：增加或更换蝶形弹簧。 Solutions: add or change S spring. 由于不合适的安全销、安全销座造成负荷过大而造成环模开裂。 Due to improper safety pin, safety pin seat causes heavy load and then ring die crack. 解决办法：必须使用本公司提供的安全销。 Solutions:Use the safety pin supplied by our company. 由于除铁装置效果变差使环模工侔面有金属物体压痕，而导致环模开裂。 Due to iron dust remover bad effect, iron dust into ring die, lead to ring die crack. 解决办法：必须及时检查并清理除铁设备。 Solutions: have to check and clean iron