海洋柔性管道接头楔形环锯齿密封性能数值模拟.pdf

海管与船运 2018 年1 月　第37 卷第1 期 Subsea pipeline Shipping 1000-8241 2018 01-0108-08 文章编号： （ ） 海洋柔性管道接头楔形环锯齿密封性能数值模拟 张亮　杨志勋　卢青针　阎军　陈金龙　岳前进 大连理工大学 摘要：密封环上的锯齿对非粘接管道接头密封性能影响明显，而实际分析密封结构时很难建立带锯 齿的精细模型。针对某海域使用的非粘接管道接头密封环，明确了适用的密封准则，建立了锯齿密 封模型，根据压入深度的敏感度分析得到了最佳压入深度范围，并提取了对应的放大系数，结果表 明：该模型结构有一个较优的压入深度范围，在该范围内密封性能的最大接触压力及有效密封长度 比例取值均较优；采用无锯齿简化模型结合放大系数可以近似预测真实结构的密封性能。该研究 方法可为精细化设计楔形密封环几何尺寸提供指导，同时也可为分析尺度跨度较大的结构提供思 路。（图15，表3，参20 ） 关键词：海洋柔性管道；非粘结管道；接头；楔形密封环；锯齿；密封准则；数值模拟 01 020 中图分类号：TE832 　　　　文献标识码：A　　　　 doi ： 10.6047/j.issn.1000-8241.2018. . Numerical simulation on the sealing performance of serrated teeth inside the wedgy sealing ring of end fitting of marine flexible pipeline ZHANG Liang, YANG Zhixun, LU Qingzhen, YAN Jun, CHEN Jinlong, YUE Qianjin Dalian University of Technology Abstract: The serrated teeth in the sealing ring have significant effect on the sealing performance of end fitting of unbounded pipeline, but it is practically difficult to establish a fine model to analyze the sealing structure with serrated teeth. In this paper, the sealing ring inside the end fitting of unbonded pipeline used in one certain sea area was taken as an example. The suitable sealing criterion was defined and the sealing model with serrated teeth was established. Then, the range of optimal penetration depth was obtained based on the sensitivity analysis of penetration depth, and the amplification factor corresponding to the range of optimal penetration depth was